Cisco AIR-WLC2006-K9 - Wireless LAN Controller 2006 Guía de usuario descargar pdf (Pagina 118)

4-8

Cisco Wireless LAN Solution Product Guide

OL-7955-01

Chapter 4 Configuring Controller Settings

Configuring Mobility Groups

Step 4 Enter config snmp community ipaddr ip-address ip-mask name to configure an IP address and subnet

mask for an SNMP community.

Step 5 Enter config snmp community mode enable to enable a community name. Enter config snmp

community mode disable to disable a community name.

Step 6 Enter config snmp trapreceiver create name ip-address to configure a destination for a trap.

Step 7 Enter config snmp trapreceiver delete name to delete a trap.

Step 8 Enter config snmp trapreceiver ipaddr old-ip-address name new-ip-address to change the destination

for a trap.

Step 9 Enter config snmp trapreceiver mode enable to enable traps. Enter config snmp trapreceiver mode

disable to disable traps.

Step 10 Enter config snmp syscontact syscontact-name to configure the name of the SNMP contact. Enter up to

31 alphanumeric characters for the contact name.

Step 11 Enter config snmp syslocation syslocation-name to configure the SNMP system location. Enter up to

31 alphanumeric characters for the location.

Use the show snmpcommunity and show snmptrap commands to verify that the SNMP traps and

communities are correctly configured.

Use the show trapflags command to see the enabled and disabled trapflags. If necessary, use the

config trapflags commands to enable or disable trapflags.

Configuring Mobility Groups

All Cisco Wireless LAN Controllers that can communicate with each other through their Distribution

System (network) ports can automatically discover each other and form themselves into groups. After

they are grouped, the Radio Resource Management (RRM) function maximizes its inter-controller

processing efficiency and mobility processing.

Cisco Wireless LAN Controller group discovery is automatically enabled when two or more members

are assigned to the same mobility group name. Note that this feature must be enabled on each Cisco

Wireless LAN Controller to be included in the discovery process.

Follow these steps to configure mobility groups:

Step 1 Enter show mobility summary to check the current mobility settings.

Step 2 Enter config mobility group name group_name to create a mobility group. Enter up to 31 case-sensitive

ASCII characters for the group name. Spaces are not allowed in mobility group names.

Step 3 Enter config mobility group member add mac-address ip-addr to add a group member. Enter config

mobility group member delete mac-address ip-addr to delete a group member.

Step 4 Enter show mobility summary to verify the mobility configuration.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 259 260

Sin comentarios

Cisco AIR-WLC2006-K9 - Wireless LAN Controller 2006 Guía de usuario Pagina 118