Cisco AIR-WLC2006-K9 - Wireless LAN Controller 2006 Guía de usuario descargar pdf (Pagina 141)

7-5

Cisco Wireless LAN Solution Product Guide

OL-7955-01

Chapter 7 Configuring Management Interfaces and Ports

Enabling Web and Secure Web Modes

• config interface address virtual ip-address

–

For ip-address, enter any fictitious, unassigned, unused gateway IP address.

• config interface hostname virtual dns-host-name

Step 4 Enter reset system. At the confirmation prompt, enter y to save configuration changes to NVRAM. The

controller reboots.

Step 5 Enter show interface detailed virtual to verify that the controller saved your changes.

Enabling Web and Secure Web Modes

Use these commands to enable or disable the distribution system port as a web port or as a secure web

port:

• config network webmode {enable | disable}

• config network secureweb {enable | disable}

Web and secure web modes are enabled by default.

Configuring Spanning Tree Protocol

Spanning Tree Protocol (STP) is disabled for the distribution system (network) ports by default. Use

these commands to enable STP on the controller for all physical ports:

Step 1 Enter show spanningtree port and show spanningtree switch commands to view the current STP

status.

Step 2 If STP is enabled, you must disable it before you can change STP settings. Enter config spanningtree

switch mode disable to disable STP on all ports.

Step 3 Use these commands to configure the STP port administrative mode:

• config spanningtree port mode 802.1d {port-number | all}

• config spanningtree port mode fast {port-number | all}

• config spanningtree port mode off {port-number | all}

Step 4 Enter these commands to configure the STP port path cost on the STP ports. Use this command to specify

a path cost from 1 to 65535 to the port:

• config spanningtree port pathcost 1-65535 {port-number | all}

Use this command to allow the STP algorithm to automatically assign the path cost. This is the default

setting:

• config spanningtree port mode pathcost auto {port-number | all} (default)

Step 5 Enter config spanningtree port priority 0-255 port-number to configure port priority on STP ports. The

default priority is 128.

Step 6 If necessary, enter config spanningtree switch bridgepriority 0-65535 to configure the controller STP

bridge priority. The default bridge priority is 32768.

Step 7 If necessary, enter config spanningtree switch forwarddelay 4-30 to configure the controller STP

forward delay in seconds. The default forward delay setting is 15 seconds.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 259 260

Sin comentarios

Cisco AIR-WLC2006-K9 - Wireless LAN Controller 2006 Guía de usuario Pagina 141