Cisco AIR-WLC2006-K9 - Wireless LAN Controller 2006 Guía de usuario descargar pdf (Pagina 181)

10-7

Cisco Wireless LAN Solution Product Guide

OL-7955-01

Chapter 10 Configuring and Using Location Appliances

Configuring Location Appliances

Editing Location Appliance Location Parameters

After you add a location appliance to the Cisco WCS database you can specify whether the location

appliance retains its heatmap persistence, whether the location appliance retains its calculation times,

and how soon the location appliance deletes its collected RSSI measurement times. WCS users can

display the location appliance historical data at any time.

Step 1 In the Cisco WCS interface, select LOCATE to display the All Location Appliances page.

Step 2 Click the server name to display the Location Appliance > General Properties > appliance-name page.

Step 3 In the left navigation bar, click Location Parameters to have Cisco WCS display the Location

Appliance > Location Parameters > appliance-name page.

Step 4 Configure these settings:

• Enable heatmap persistence: Select the check box to have the location appliance retain its heatmap

persistence. Heatmap persistence is disabled by default.

• Enable calculation time: Select the check box to have the location appliance retain its calculation

times. Calculation time retention is disabled by default.

• Discard RSSI measurement time: Enter the number of minutes (between 0 and 99999 minutes) for

the location appliance to retain its collected RSSI values. The default setting is 480 minutes. When

the retention time elapses the location appliance purges its older RSSI values.

Step 5 Click Save to store your selections in the Cisco WCS and location appliance databases.

Managing Location Appliance User Groups

This section describes how to add, change, and delete users and user groups on location appliances.

Adding Location Appliance User Groups

WCS SuperUsers can add or delete user groups for location appliances. Follow these steps to add or

delete a user group:

Step 1 In the Cisco WCS interface, select LOCATE to display the All Location Appliances page.

Step 2 Click the server name to display the Location Appliance > General Properties > appliance-name page.

Step 3 Click Groups to display the Location Appliance > Groups > appliance-name page.

Step 4 In the right-hand command drop-down menu, select Add Group and click GO to display the New Group

page.

Step 5 Enter the new group name and assign a Read Access, Write Access, or Full Access permission for the

group.

Step 6 Click Save to add the new group to the location appliance.

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 259 260

Sin comentarios

Cisco AIR-WLC2006-K9 - Wireless LAN Controller 2006 Guía de usuario Pagina 181