Cisco AIR-WLC2006-K9 - Wireless LAN Controller 2006 Guía de usuario descargar pdf (Pagina 179)

10-5

Cisco Wireless LAN Solution Product Guide

OL-7955-01

Chapter 10 Configuring and Using Location Appliances

Configuring Location Appliances

Editing Location Appliance Polling Parameters

After you add a location appliance to the WCS database you can modify the independent Client, Rogue

Access Point, Asset Tag, and Statistics polling periods that the location appliance uses to poll its

associated controllers. Note that these polling periods are independent of the number of times that WCS

users request a data refresh from the location appliance.

Step 1 In the Cisco WCS interface, select LOCATE to display the All Location Appliances page.

Step 2 Click the server name to display the Location Appliance > General Properties > appliance-name page.

Step 3 In the left navigation bar, click Polling Parameters to display the Location Appliance > Polling

Parameters > appliance-name page.

Step 4 Configure these settings:

• Retry Count: Enter the number of times to retry a polling cycle between 1 and 99999. The default

setting is 3. The Retry Count generally does not need to be changed from the default.

• Timeout: Enter the number of seconds for a polling timeout between 1 and 99999. The default

setting is 5 seconds. The Timeout generally does not need to be changed from the default.

• Client Station Polling and Interval: Select the check box to turn Polling on, and enter the number

of seconds between Client polling attempts between 1 and 99999. Polling is disabled by default with

a 300-second interval. You might want to leave Client Polling disabled, and you might want to

change the Polling Interval to a shorter value for more granular data collection or to a longer value

for less granular data collection.

Note The Polling Interval is the period between the end of a preceding polling cycle and the beginning of the

next polling cycle. That is, if the polling cycles take five minutes to complete, and the Polling Interval

is ten minutes, the time between the start of polling cycles is fifteen minutes.

• Rogue AP Polling and Interval: Select the check box to turn Polling on, and enter the number of

seconds between rogue access point polling attempts between 1 and 99999. Polling is disabled by

default with a 600-second interval. You might want to leave rogue access point Polling off, and you

might want to change the Polling Interval to a shorter or longer value for more or less granular data

collection, respectively.

• Asset Tag Polling and Interval: Select the check box to turn Polling on, and enter the number of

seconds between Asset Tag polling attempts between 1 and 99999. Polling is disabled by default

with a 600-second interval. You might want to leave Asset Tag Polling off, and you might want to

change the Polling Interval to a shorter or longer value for more or less granular data collection,

respectively.

Note Before the location appliance can collect asset tag data, the controllers to which it is associated

must have RFID status enabled through this CLI command: config rfid status enable.

• Statistics Polling and Interval: Select the check box to turn Polling on, and enter the number of

seconds between Statistics polling attempts between 1 and 99999. Polling is disabled by default with

a 900-second interval. You might want to leave Statistics Polling off, and you might want to change

the Polling Interval to a shorter or longer value for more or less granular data collection,

respectively.

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 259 260

Comentarios a estos manuales

Sin comentarios

Cisco AIR-WLC2006-K9 - Wireless LAN Controller 2006 Guía de usuario Pagina 179

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cisco AIR-WLC2006-K9 - Wireless LAN Controller 2006