Cisco AIR-WLC2006-K9 - Wireless LAN Controller 2006 Guía de usuario descargar pdf (Pagina 66)

1-42

Cisco Wireless LAN Solution Product Guide

OL-7955-01

Chapter 1 Overview

Autonomous Access Points Converted to Lightweight Mode

On the controller CLI, enter this command to pull the core file from the access point:

config ap get-radio-core-dump slot ap-name

For slot, enter the radio interface number on the access point.

The retrieved core file is stored in the controller flash and can subsequently be uploaded through TFTP

to an external server for analysis. The core file is removed from the access point flash memory when the

controller pulls it from the access point.

Enabling Memory Core Dumps from Converted Access Points

By default, access points converted to lightweight mode do not send memory core dumps to the

controller. To enable this feature, enter this command:

config ap core-dump enable tftp-server-ip-address filename {compress | uncompress} {ap-name | all}

• For tftp-server-ip-address, enter the IP address of the TFTP server to which the access point sends

core files. The access point must be able to reach the TFTP server.

• For filename, enter a filename that the access points uses to label the core file.

• Enter compress to configure the access point to send compressed corefiles. Enter uncompress to

configure the access point to send uncompressed core files.

• For ap-name, enter the name of a specific access point, or enter all to enable memory core dumps

from all access points converted to lightweight mode.

Display of MAC Addresses for Converted Access Points

There are some differences in the way that controllers display the MAC addresses of converted access

points on information pages in the controller GUI:

• On the AP Summary page, the controller lists the Ethernet MAC addresses of converted access

points.

• On the AP Detail page, the controller lists the BSS MAC addresses and Ethernet MAC addresses of

converted access points.

• On the Radio Summary page, the controller lists converted access points by radio MAC address.

Disabling the Reset Button on Access Points Converted to Lightweight Mode

You can disable the reset button on access points converted to lightweight mode. The reset button is

labeled MODE on the outside of the access point.

Use this command to disable or enable the reset button on one or all converted access points associated

to a controller:

config ap reset-button {enable | disable} {ap-name | all}

The reset button on converted access points is enabled by default.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 259 260

Sin comentarios

Cisco AIR-WLC2006-K9 - Wireless LAN Controller 2006 Guía de usuario Pagina 66