
5-10
Cisco Wireless LAN Solution Product Guide
OL-7955-01
Chapter 5 Configuring Wireless LANs
Configuring Wireless LANs
Adding Anchors for a Wireless LAN
Follow these steps to configure auto anchoring:
Step 1 Add controllers to the mobility member list. Enter config mobility group member add mac-address
ip-addr to add a controller to a mobility group. Refer to the “Configuring Mobility Groups” section on
page 4-8 for more information on creating mobility groups.
Step 2 Enter config wlan disable wlan-id to disable the wireless LAN for which you are configuring anchor
controllers.
Step 3 Enter config mobility group anchor add wlan-id anchor-controller-ip-address to specify an anchor
controller for a wireless LAN. The wireless LAN must already be configured but must not be enabled.
Auto anchoring is enabled for the wireless LAN when you configure the first anchor controller.
To complete this step on the controller GUI, browse to the WLAN > Mobility Anchors page, select a
controller IP address, and click Mobility Anchor Create.
Deleting Anchors for a Wireless LAN and Disabling Auto Anchoring
To delete an anchor controller for a wireless LAN, disable the wireless LAN and enter this command:
config mobility group anchor delete wlan-id anchor-controller-ip-address
When you delete all the anchor controllers for a wireless LAN, auto anchoring is disabled for that
wireless LAN.
Displaying Auto Anchor Controllers
Enter show mobility anchor [wlan-id] to display a list of controllers configured as anchors for a specific
wireless LAN. To display all anchor controllers on your system, enter show mobility anchor.
Comentarios a estos manuales