Cisco WS-X6708-10G-3CXL= - 10 Gigabit Ethernet Module Manual de usuario descargar pdf (Pagina 24)

White Paper

slot 1 slot-type 254 port-type 31 number 2 port-type 61 number 1 port-type 60 number 2

virtual-slot 33

slot 2 slot-type 148 port-type 60 number 4 virtual-slot 34

slot 3 slot-type 147 port-type 61 number 48 virtual-slot 35

Modules are provisioned in the configuration to allow for parsing even if they are not present in the chassis. This

situation occurs when one of the member switches is not yet online but the configuration needs to be parsed.

With the following command you can determine that the Cisco Virtual Switching System is now operating and that the

two switches are acting as a single, logical network node.

VSS#show switch virtual

Switch mode : Virtual Switch

Virtual switch domain number : 100

Local switch number : 1

Local switch operational role: Virtual Switch Active

Peer switch number : 2

Peer switch operational role : Virtual Switch Standby

If the conversion process is performed using software release 12.2(33)SXI3 or newer then the conversion process is

complete once the two supervisors reach the SSO Standby Hot redundancy mode. If the conversion is performed

using a software release prior to 12.2(33)SXI3 then there is one more critical step to perform in order to finalize the

conversion.

Again, this final, critical step is applicable only for a first-time conversion, and only applicable to systems converted

using a software release prior to 12.2(33)SXI3.

During the conversion process, the configuration of the standby virtual switch (in this case, switch 2) is cleared,

including the configuration of the two VSL interfaces on the switch. If the switch were to reload at this point it would

not have the information available to determine which interfaces to use for VSL communication. Therefore the

configuration for the VSL interfaces on the standby switch must be applied, or merged from the active switch

configuration. In order to facilitate this information to be repopulated again, you must complete step 4.

Step 4. Finalize the Virtual Switch Conversion

When the standby virtual switch is in SSO hot mode, you must execute the following command to automatically

configure the standby virtual switch configuration on the active virtual switch:

VSS#switch accept mode virtual

This command will bring in all VSL configurations from the standby switch and populate

it into the running configuration.

In addition the startup configurations will be updated with the new merged

configurations.

Do you want proceed? [yes/no]: yes

Merging the standby VSL configuration. . .

Building configuration...

[OK]

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 61 62

Sin comentarios

Cisco WS-X6708-10G-3CXL= - 10 Gigabit Ethernet Module Manual de usuario Pagina 24