Cisco WS-X6708-10G-3CXL= - 10 Gigabit Ethernet Module Manual de usuario Pagina 25

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 62
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 24
White Paper
© 2010 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Inf ormation. Page 25 of 62
This command prompts you to accept all standby virtual switch VSL-related configurations and also updates the
startup configuration with the new merged configurations. Note that only VSL-related configurations are merged with
this stepall other configurations will be lost and require manual intervention.
If entering this command running a 12.2(33)SXI3 or newer software release the command returns a notification that
this step is no longer necessary.
VSS#
Corel#switch accept mode virtual
This command is no longer required since standby VSL configuration merge is done
automatically.
VSS#
Operational Management
Management of the system as a whole changed with the advent of the Cisco Virtual Switching System. The
fundamental concept of a switching system has evolved from a single physical entity managed separately to multiple
physical entities that are managed as a single system. The following section examines areas such as console
management, in-band (Telnet or SSH) management, SNMP and MIB changes, effects of NVRAM, NetFlow features,
Switch Port Analyzer (SPAN), Embedded Event Manager (EEM), and CiscoWorks LAN Management System (LMS)
management.
Console Management
After the two individual switches are converted into a Virtual Switching System, the console access is restricted to
only the active virtual switch. In this case you can handle all configuration, monitoring, and troubleshooting under a
single interface. The console output into the standby virtual switch indicates that the console is disabled for general
administrative purposes. (See Figure 14.)
Figure 14. Active and Standby Consoles
If a switchover occurs and switch 2 becomes the active virtual switch, the console becomes active on that supervisor
engine.
Interface Numbering
After conversion to a Virtual Switching System, the interface numbering changes from a traditional scheme:
<INTERFACE_TYPE> <MODULE>/<PORT>
Vista de pagina 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 61 62

Comentarios a estos manuales

Sin comentarios