Cisco 6400 Guia de preparacion descargar pdf (Pagina 162)

B-16

Cisco 6400 Software Setup Guide

OL-1183-04

AppendixB Upgrading Software on the Cisco 6400

Upgrading Software on Redundant NSPs

Upgrade the Primary NSP Images

Complete the following steps to upgrade the software images on the primary NSP. The NSP in slot 0A

is still the primary device, and the NSP in slot 0B is still the secondary device.

Step 1 Use the dir EXEC command to locate and identify the images you want to replace on the primary NSP.

Switch# dir disk0:

Switch# dir disk1:

Switch# dir bootflash:

Step 2 Use the copy EXEC command to back up the primary NSP images to a TFTP server.

Switch# copy disk0:c6400s-wp-mz.120-7.DB tftp://10.1.1.1/c6400s-wp-mz.120-7.DB

Switch# copy disk0:c6400s-html.tar.120-5.DB tftp://10.1.1.1/c6400s-html.tar.120-5.DB

Switch# copy bootflash:c6400s-wp-mz.120-5.DB tftp://10.1.1.1/c6400s-wp-mz.120-5.DB

Step 3 Use the delete, and for boot flash, the squeeze EXEC commands to delete the old images.

Switch# delete disk0:c6400s-wp-mz.120-7.DB

Switch# delete disk0:c6400s-html.tar.120-5.DB

Switch# delete bootflash:c6400s-wp-mz.120-5.DB

Switch# squeeze bootflash

Step 4 Use the copy EXEC command to load the new images.

Switch# copy tftp://10.1.1.1/c6400s-wp-mz.122-13.T disk0:c6400s-wp-mz.122-13.T

Switch# copy tftp://10.1.1.1/c6400s-html.tar.122-13.T disk0:c6400s-html.tar.122-13.T

Switch# copy tftp://10.1.1.1/c6400s-wp-mz.DB1 bootflash:c6400s-wp-mz.122-13.T

Step 5 Use the no boot system global configuration command to remove the old startup image configuration.

Switch(config)# no boot system flash:c6400s-wp-mz.120-7.DB

Step 6 Use the boot system global configuration command to add the new startup image configuration.

Switch(config)# boot system flash:c6400s-wp-mz.122-13.T

Step 7 Use the config-register global configuration command to do one of the following:

a. Set the config register to 0x2 for automatic boot.

Switch(config)# config-register 0x2

b. Set the config register to 0x0 to boot manually from the ROMMON prompt.

Switch(config)# config-register 0x0

Step 8 Use the copy EXEC command to save the running configuration as the startup configuration.

Switch# copy system:running-config nvram:startup-config

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 197 198

Sin comentarios

Cisco 6400 Guia de preparacion Pagina 162