Cisco 6400 Guia de preparacion descargar pdf (Pagina 43)

2-19

Cisco 6400 Software Setup Guide

OL-1183-04

Chapter2 Basic NSP Configuration

NRP-2 and NRP-2SV Support

Verifying ATM Static Routes for IISP or PNNI

To verify successful configuration of an ATM static route, use the show atm route and

showatmpnnitopology EXEC commands.

NRP-2 and NRP-2SV Support

The NSP provides the following functions for the NRP-2 and NRP-2SV:

• Image and File Storage, page 2-19

• System Logging, page 2-21

• Console and Telnet Access, page 2-21

• SNMPv3 Proxy Forwarder, page 2-22

• Troubleshooting and Monitoring the NRP-2, page 2-22

Note Unless a clear distinction is made, all references to the NRP-2 also apply to the NRP-2SV.

Image and File Storage

The NRP-2 has no local image or file storage. The NSP stores the following NRP-2 files on the Personal

Computer Memory Card International Association (PCMCIA) disk:

• NRP-2 images

• NRP-2 system configuration files

• NRP-2 ROM state information

• Crash information

Note A PCMCIA disk must be in NSP disk slot 0.

Whenever the NSP reloads, a PCMCIA disk is inserted, or the PCMCIA disk is formatted, the NSP

checks for the following directories on the PCMCIA disk and automatically creates those that are

missing:

• images—One directory for storing NRP-2 images.

• slot1, slot2,..., slot8—Eight directories for storing files for specific NRP-2 slots. Each slot directory

normally contains the following files when an NRP-2 is present in the slot:

–

Startup configuration file (nrp2-startup-config)

–

ROMMON variables (nrp2_rommon_nv.0)

–

Crash information (crashinfo_yyyymmdd-hhmmss)

Note Do not remove the image and slot directories. Also, make sure that you understand the consequences

before you delete any files in these directories.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 197 198

Sin comentarios

Cisco 6400 Guia de preparacion Pagina 43