Cisco MC3810 Guía de instalación descargar pdf (Pagina 22)

Configuring Voice Ports

Release 12.0(7)XK

router(config-voiceport)# connection {plar |

tie-line | trunk | plar-opx}

destination-string

[answer-mode]

Specify the voice-port connection type and the destination

telephone number.

• plar speciﬁes a private line automatic ring down (PLAR)

connection. PLAR is an autodialing mechanism that

permanently associates a voice interface with a far-end voice

interface, allowing call completion to a speciﬁc telephone

number or PBX without dialing. When the calling telephone

goes off hook a predeﬁned network dial peer is automatically

matched, which sets up a call to the destination telephone or

PBX.

• tie-line speciﬁes a connection that emulates a temporary

tie-line trunk to a private branch exchange (PBX). A tie-line

connection is automatically set up for each call and torn down

when the call ends.

• trunk speciﬁes a connection that emulates a permanent trunk

connection to a private branch exchange (PBX). A trunk

connection remains “nailed up” in the absence of any active

calls.

• plar-opx speciﬁes a PLAR Off-Premises eXtension

connection. Using this option, the local voice-port provides a

local response before the remote voice-port receives an

answer. On FXO interfaces, the voice-port will not answer

until the remote side answers.

• destination-string speciﬁes the destination telephone number.

When conﬁguring Cisco-trunk permanent calls, one side must be

the call initiator (master) and the other side is normally the call

answerer (slave). By default, the voice port operates in master

mode. Enter the answer-mode keyword to specify that the voice

port should operate in slave mode.

router(config-voiceport)# voice

confirmation-tone

If connection plar-opx is conﬁgured, enable the two-beep

conﬁrmation tone that a caller hears when picking up the

handset.

router(config-voiceport)# dial-type {dtmf | pulse

| mf }

Select the dial type for dialing out.

• dtmf for touch-tone (the default)

• pulse for rotary dial

• mf for multifrequency tone dialing

router(config-voiceport)# operation {2-wire |

4-wire}

Select the appropriate cabling scheme for this voice port.

Step Command Purpose

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 77 78

Comentarios a estos manuales

Sin comentarios

Cisco MC3810 Guía de instalación Pagina 22

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas de fax Cisco MC3810