Cisco MC3810 Guía de instalación descargar pdf (Pagina 76)

voice-class codec (dial-peer)

Release 12.0(7)XK

voice-class codec (dial-peer)

To assign a previously-conﬁgured codec selection preference list (codec voice class) to a VoIP dial

peer, enter the voice-class codec dial-peer conﬁguration command. Enter the no form of this

command to remove the codec preference assignment from the dial peer.

voice-class codec tag

no voice-class codec tag

Syntax Description

Defaults

Dial peers have no codec voice class assigned.

Command Modes

Dial-peer conﬁguration

Command History

Usage Guidelines

You can assign one voice class to each VoIP dial peer. If you assign another voice class to a dial peer,

the last voice class assigned replaces the previous voice class.

Note The voice-class codec command in dial-peer conﬁguration mode is entered with a hyphen.

The voice class codec command in global conﬁguration mode is entered without the hyphen.

Examples

The following example showshow to assign a previously-conﬁgured codec voiceclass to a dial peer:

router(config)# dial-peer voice 100 voip

router(config-dial-peer)# voice-class codec 10

tag The unique number assigned to the voice class. The valid range for this

tag is 1 to 10000. The tag number maps to the tag number created using

the voice class codec global configuration command.

Release Modification

12.0(2)XH This command was introduced on the Cisco AS5300.

12.0(7)T This command was first supported on the Cisco 2600 and

3600 series routers.

12.0(7)XK This command was first supported on the Cisco MC3810

series.

1 2 ... 71 72 73 74 75 76 77 78

Sin comentarios

Cisco MC3810 Guía de instalación Pagina 76