Cisco MC3810 Guía de instalación descargar pdf (Pagina 74)

voice class codec

Release 12.0(7)XK

voice class codec

To enter voice-class conﬁguration mode and assign an identiﬁcation tag number for a codec voice

class, use the voice class codec global conﬁguration command. Use the no form of this command to

delete a codec voice class.

voice class codec tag

no voice class codec tag

Syntax Description

Command Modes

Global conﬁguration

Command History

Usage Guidelines

This command only creates the voice class for codec selection preference, and assigns an

identiﬁcation tag. Use the codec preference command to specify the parameters of the voice class,

and use the voice-class codec dial-peer command to apply the voice class to a VoIP dial peer.

Note The voice class codec command in global conﬁguration mode is entered without the hyphen.

The voice-class codec command in dial-peer conﬁguration mode is entered with the hyphen.

Example

The following example shows how to enter voice-class conﬁguration mode and assign a voice class

tag number starting from global conﬁguration mode:

router(config)# voice class codec 10

router(config-class)#

After you enter voice-class conﬁguration mode for codecs, use the codec preference command to

specify the parameters of the voice class.

tag The unique number you assign to the voice class. The valid range is 1

to 10000. Each tag number must be unique on the router.

Release Modification

12.0(2)XH This command was introduced on the Cisco AS5300.

12.0(7)T This command was first supported on the Cisco 2600 and

3600 series routers.

12.0(7)XK This command was first supported on the Cisco MC3810

series.

1 2 ... 69 70 71 72 73 74 75 76 77 78

Sin comentarios

Cisco MC3810 Guía de instalación Pagina 74