Cisco WS-C3550-24-FX-SMI - Catalyst 3550 100BASE-FX Switch Guía de instalación descargar pdf (Pagina 54)

Chapter 2 Installing and Starting the Switch

Installing the Switch

2-8

Catalyst 3550 Multilayer Switch Hardware Installation Guide

78-11358-03

–

Two 23-inch rack-mounting brackets (with 1-inch spacing for telco

racks)

–

Four number-8 Phillips truss-head screws for attaching the brackets to

the switch

–

Two number-12 Phillips machine screws for attaching the brackets to a

rack

Note The DC-switch kit ships only with the Catalyst 3550-24-DC switch.

• One RJ-45-to-DB-9 adapter cable

• Cisco Information Packet, containing warranty, safety, and support

information

Installing the Switch

These sections describe the steps required to install the switch in a rack, on a wall

or on a table or shelf.

Rack Mounting

Warning

To prevent bodily injury when mounting or servicing this unit in a rack, you must

take special precautions to ensure that the system remains stable. The

following guidelines are provided to ensure your safety:

• This unit should be mounted at the bottom of the rack if it is the

only unit in the rack.

• When mounting this unit in a partially filled rack, load the rack

from the bottom to the top with the heaviest component at the

bottom of the rack.

• If the rack is provided with stabilizing devices, install the

stabilizers before mounting or servicing the unit in the rack.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 149 150

Sin comentarios

Cisco WS-C3550-24-FX-SMI - Catalyst 3550 100BASE-FX Switch Guía de instalación Pagina 54