Cisco WS-C3550-24-FX-SMI - Catalyst 3550 100BASE-FX Switch Guía de instalación Pagina 65

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 150
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 64
2-19
Catalyst 3550 Multilayer Switch Hardware Installation Guide
78-11358-03
Chapter 2 Installing and Starting the Switch
Installing the Switch
Wall Mounting
To install the switch on a wall, follow the instructions in these procedures:
Attaching the Brackets to the Switch for Wall-Mounting, page 2-19
Attaching the RPS Connector Cover, page 2-20
Mounting the Switch on a Wall, page 2-21
Note The illustrations in this section show the Catalyst 3550-12T switch as an example.
All the Catalyst 3550 switches are wall-mounted following the same procedures.
Attaching the Brackets to the Switch for Wall-Mounting
Figure 2-17 shows how to attach a 19-inch bracket to one side of the switch.
Follow the same steps to attach the second bracket to the opposite side.
Figure 2-17 Attaching the 19-inch Brackets for Wall-Mounting
Note Before you attach the brackets on the Catalyst 3550-24-FX switch, remove the
screws that are in the middle of the chassis. Attach the bracket by using the
supplied Phillips flat-head screws, as shown in Figure 2-17.
100-240V~
5-3A
50/60Hz
CONSOLE
51368
Phillips
truss-head
screws
Vista de pagina 64
1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 149 150

Comentarios a estos manuales

Sin comentarios