Cisco 6050 Guía de usuario descargar pdf (Pagina 12)

McAfee® IntruShield® IPS 4.1 Overview

M-6050 Sensor Product Guide M-6050 physical description

5 Eight 10 Gigabit small form-factor pluggable (XFP) 10 Gigabit Monitoring ports, which enable

you to monitor eight SPAN ports, four full-duplex tapped segments, four

segments in-line, or a combination (that is, two full-duplex segment, four SPAN

ports).

The Monitoring interfaces of the M-6050 work in stealth mode, meaning they

have no IP address and are not visible on the monitored segment.

If you choose to run in failover mode, port 4A is used to interconnect with a

standby sensor.

Note: The gigabit ports of the M-6050 running in In-line Mode fail closed,

meaning that if the sensor fails, it will interrupt/block data flow. Fail-open

functionality requires either the Layer 2 Passthru feature, described in detail in

the Sensor Configuration Guide—using ISM or the hardware Gigabit Fail-Open

Bypass kit for Gigabit ports, described in

Cabling the failover interconnection

ports section.

6 One RJ-45 Response port, which, when you’re operating in SPAN or TAP mode,

enables you to inject response packets back through a switch or router.

Eight RJ-11 Fail-Open Control ports, designed for use with the Optical Fail-Open

Bypass kit. The ports are marked X1, X2, X3, X4, X5, X6, X7, and X8 and are

used in conjunction with ports 1A/1B, 2A/2B, 3A/3B, 4A/4B, 5A/5B, 6A/6B,

7A/7B, and 8A/8B, respectively.

8 One External Compact Flash port. This port is used for two purposes. It is used to

control optional fail-open hardware as described in the

Gigabit Optical Fail-Open

Bypass Kit Quick Guide

. It is also used in troubleshooting situations where the

sensor’s internal flash is corrupted and you must reboot the sensor using the

external compact flash. For more information, see the on-line KnowledgeBase at

https://mysupport.mcafee.com.

Power Supply A (included). Power supply A is included with each sensor. The

supply uses a standard IEC port (IEC320-C13). The supply uses a standard IEC

port (IEC320-C13). McAfee provides a standard, 2m NEMA 5-15P (US) power

cable (3 wire). International customers must procure a country-appropriate power

cable.

Power Supply B (optional, purchased separately). Power supply B is a hot-

swappable, redundant power supply. This power supply also uses a standard

IEC320-C13 port, and you can use the McAfee-provided cable or acquire one

that meets your specific needs.

The M-6050 does not have internal taps; it must be used with a third-party external

tap to run in tapped mode.

Front panel LEDs

The front panel LEDs provide status information for the health of the sensor and the

activity on its ports. Table 1-1 describes the M-6050 front panel LEDs.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 34 35

Comentarios a estos manuales

Sin comentarios

Cisco 6050 Guía de usuario Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Cámaras De Seguridad Cisco 6050