Cisco 6050 Guía de usuario descargar pdf (Pagina 20)

McAfee® IntruShield® IPS 4.1 Setting up an M-6050

M-6050 Sensor Product Guide Using the redundant power supply

Using the redundant power supply

A basic configuration of the M-6050 includes one hot swappable supply. You may

install a second hot-swappable power supply (purchased separately from McAfee) for

redundancy.

Each of these modules has one handle for insertion or extraction from the unit as well

as a release latch.

Figure 4: Power supply units

Installing the power supply

To install a power supply in the M-6050:

1 Unpack the power supply from its shipping carton.

2 Remove the faceplate panel covering the power supply slot.

Note: The faceplate panel should remain in place unless a power supply is in

the power supply slot.

3 Do not operate the sensor without the faceplate panel in place.

4 Place the power supply in the slot with the cable outlet facing front and on the

left side of the faceplate.

Figure 5: Power supply installation

5 Slide in the power supply until it makes contact with the backplane, then push

firmly to mate the connectors solidly with the backplane.

Note: For true redundant operation with the optional redundant power supply,

McAfee recommends that you plug each supply into a different power circuit. For

optimal protection, use uninterruptable power sources.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 34 35

Sin comentarios

Cisco 6050 Guía de usuario Pagina 20