Cisco 6050 Guía de usuario descargar pdf (Pagina 25)

C HAPTER 4

Attaching Cables to the M-6050

Follow the steps outlined in this chapter to connect cables to the various ports on

your sensor.

Cabling the Console port

The Console port is used for setup and configuration of the sensor.

1 For console connections, plug the DB9 Console cable supplied by McAfee into

the

Console port (labeled Console on the sensor front panel).

2 Connect the other end of the Console port cable directly to a COM port of the PC

or terminal server you will use to configure the sensor (for example, a PC running

correctly configured Windows HyperTerminal software). You must connect

directly to the console for initial configuration.

Required settings for HyperTerminal are:

Name Setting

Baud rate 38400

Number of bits 8

Parity None

Stop bits 1

Flow Control None

3 Power on the sensor.

Cabling the Auxiliary port

The Auxiliary (Aux) port is also used for modem access to the sensor for setup and

configuration.

You cannot use a modem the first time you configure a sensor.

1 For modem connections, plug a straight-through modem cable into the Auxiliary

port (labeled

Aux on the sensor front panel).

2 Connect a modem to the

Aux port.

Connect a telephone line to the modem.

Required settings for the

Aux port are:

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 34 35

Sin comentarios

Cisco 6050 Guía de usuario Pagina 25