Cisco 6050 Guía de usuario descargar pdf (Pagina 21)

McAfee® IntruShield® IPS 4.1 Setting up an M-6050

M-6050 Sensor Product Guide Cabling the sensor

Removing the power supply

To remove a power supply from the M-6050 (Optional—the power supplies are hot-

swappable):

1 Unplug the power cable from its power source and remove the power cable from

the power supply.

2 Put on an antistatic wrist or ankle strap. Attach the strap to a bare metal surface

of the chassis.

3 Push the release latch inward toward the handle.

4 Squeeze the handle of the power supply and pull it out.

5 Use faceplate panels to protect unused slots from dust and reduce

electromagnetic radiation.

6 Replace the mounting bracket.

Warning 1: To remove all power from the M-6050 sensor, unplug all power cords.

Warning 2: To avoid data interruption, do not power off both power supplies on an

in-line sensor, or the sensor shuts down and all data traffic stops. Power off only the

power supply you are replacing.

Cabling the sensor

Follow the steps outlined in Attaching Cables to the M-6050 Sensor to connect cables

to the monitoring, response, console, and management ports on your sensor.

Using Small Form-factor Pluggable modules

The M-6050 uses two types of Small Form-factor Pluggable modules as shown in the

table.

Type Performance

SPF 10/100/1000 Mbps (copper)

1 Gbps (fiber optic)

XFP 10 Gbps (fiber optic)

Each module is a hot-swappable input/output device that plugs into an LC-type

Gigabit Ethernet port, linking the module port with a copper or fiber-optic network.

SFP optical interfaces are less than half the size of GBIC interfaces.

Note: To ensure compatibility, McAfee supports only those SFP and XFP modules

purchased through McAfee or from a McAfee-approved vendor. For a list of

approved vendors, see the on-line KnowledgeBase,

https://support.mcafee.com.

https://mysupport.mcafee.com

These installation instructions provide information for installing an SFP and an XFP

module that uses a bail clasp for securing the module in place in the sensor. Your

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 34 35

Sin comentarios

Cisco 6050 Guía de usuario Pagina 21