Cisco 6050 Guía de usuario descargar pdf (Pagina 31)

C HAPTER 5

Troubleshooting

This section lists some common installation problems and their solutions.

Problem Possible Cause Solution

LED is off. The control cable has been

disconnected.

Check the control cable and ensure it

is properly connected to both the

sensor and the Bypass Switch.

LED is off. The sensor is powered off. Restore sensor power.

LED is off. The sensor port cable is

disconnected.

Check the sensor cable connections.

Sensor is operational,

but is not monitoring

traffic.

Network device cables have

been disconnected.

Check the cables and ensure they are

properly connected to both the network

devices and the Bypass Switch.

Sensor is operational,

but is not monitoring

traffic.

The sensor ports have not

been enabled in the Manager.

The sensor will not monitor traffic on

the ports unless the ports are enabled

in the Manager. Ports are disabled in a

sensor failure; they must be re-

enabled for sensor monitoring to

resume.

Network or link problems. Improper cabling or port

configuration.

Ensure that the transmit and receive

cables are properly connected to the

Bypass Switch.

Runts or giants errors on

switch and routers.

Improper cabling or port

configuration.

Ensure that the transmit and receive

cables are properly connected to the

Bypass Switch.

The system fault “Switch

absent” appears in the

Manager System Health

window.

The control cable has been

disconnected.

Check the control cable and ensure it

is properly connected to both the

sensor and the Bypass Switch.

1 2 ... 26 27 28 29 30 31 32 33 34 35

Comentarios a estos manuales

Sin comentarios

Cisco 6050 Guía de usuario Pagina 31

Comentarios a estos manuales

Relacionado con productos y manuales para Cámaras De Seguridad Cisco 6050