Cisco 6050 Guía de usuario descargar pdf (Pagina 23)

McAfee® IntruShield® IPS 4.1 Setting up an M-6050

M-6050 Sensor Product Guide Power-on the sensor

Installing a module

To install a module with a bail clasp, follow these steps:

1 Remove the module from its protective packaging.

2 Ensure the module is the correct model for your network.

3 Locate the label on the module and ensure that the alignment groove is down.

Note: For SFP modules, turn the module so that its label is on top. For XFP

modules, turn the module so that its label is on bottom.

4 Grip the sides of the module with your thumb and forefinger and insert module

into the module socket.

Modules are keyed to prevent incorrect insertion.

Figure 8: Module in Monitoring port

Removing a module

If you are removing a module, follow these steps:

1 Disconnect the network fiber-optic cable from the module.

2 Release the module from the slot by pulling the bail clasp out of its locked

position.

3 Slide the module out of the slot.

4 Insert the module plug into the module optical bore for protection.

Power-on the sensor

Warning: Do not attempt to power on the sensor until you have installed the sensor

in a rack, made all necessary network connections, and connected the power cable

to the power supply.

Connect the power cable to the sensor power supply.

Connect the power cable to a power source.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 34 35

Sin comentarios

Cisco 6050 Guía de usuario Pagina 23