Cisco Catalyst 2900 Series XL Especificaciones descargar pdf (Pagina 112)

5-18

Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide

78-6511-06

Chapter 5 Clustering Switches

Creating a Switch Cluster

Enabling a Command Switch

The switch you designate to be the command switch must meet the requirements described in the

“Command Switch Characteristics” section on page 5-2, “Planning a Switch Cluster” section on

page 5-4, and the release notes

(http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/index.htm).

Note • We strongly recommend that the highest-end, command-capable switch in the cluster be the

command switch:

• If your switch cluster has a Catalyst 3550 switch, that switch should be the command switch.

• If your switch cluster has Catalyst 2900 XL, Catalyst 2950, and Catalyst 3500 XL switches, the

Catalyst 2950 should be the command switch.

• If your switch cluster has Catalyst 1900, Catalyst 2820, Catalyst 2900 XL, and Catalyst 3500 XL

switches, either the Catalyst 2900 XL or Catalyst 3500 XL should be the command switch.

You can enable a command switch, name the cluster, and assign an IP address and a password to the

command switch when you run the setup program during initial switch setup. For information about

using the setup program, refer to the release notes

(http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/index.htm).

If you did not enable a command switch during initial switch setup, launch Device Manager from a

command-capable switch, and select Cluster > Create Cluster. Enter a cluster number (the default is 0),

and use up to 31 characters to name the cluster (Figure 5-7). Instead of using CMS to enable a command

switch, you can use the cluster enable global configuration command.

Figure 5-7 Create Cluster Window

Enter up to 31 characters

to name the cluster.

56520

C3550-12T

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 321 322

Sin comentarios

Cisco Catalyst 2900 Series XL Especificaciones Pagina 112