Cisco Catalyst 2900 Series XL Especificaciones descargar pdf (Pagina 231)

8-39

Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide

78-6511-06

Chapter 8 Configuring VLANs

How the VMPS Works

Configuring Dynamic Ports on VMPS Clients

If you are configuring a port on a member switch as a dynamic port, first log into the member switch by

using the privileged EXEC rcommand command. For more information on how to use this command,

refer to the Catalyst 2900 Series XL and Catalyst 3500 Series XL Command Reference.

Caution Dynamic port VLAN membership is for end stations. Connecting dynamic ports to other switches

can cause a loss of connectivity.

Beginning in privileged EXEC mode, follow these steps to configure a dynamic port on the VMPS client

switches:

The switch port that is connected to the VMPS server should be configured as a trunk. For more

information, see the “Configuring a Trunk Port” section on page 8-27.

Reconfirming VLAN Memberships

Beginning in privileged EXEC mode, follow these steps to confirm the dynamic port VLAN membership

assignments that the switch has received from the VMPS:

Command Purpose

Step 1

configure terminal Enter global configuration mode.

Step 2

interface interface Enter interface configuration mode and the switch port that is connected to

the end station.

Step 3

switchport mode access Set the port to access mode.

Step 4

switchport access vlan dynamic Configure the port as eligible for dynamic VLAN membership.

The dynamic-access port must be connected to an end station.

Step 5

end Return to privileged EXEC mode.

Step 6

show interface interface switchport Verify the entry. In the display, check the Operational Mode field.

Command Purpose

Step 1

vmps reconfirm Reconfirm dynamic port VLAN membership.

Step 2

show vmps Verify the dynamic VLAN reconfirmation status.

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 321 322

Sin comentarios

Cisco Catalyst 2900 Series XL Especificaciones Pagina 231