Cisco Catalyst 2900 Series XL Especificaciones descargar pdf (Pagina 115)

5-21

Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide

78-6511-06

Chapter 5 Clustering Switches

Creating a Switch Cluster

Creating a Cluster Standby Group

The cluster standby group members must meet the requirements described in the “Standby Command

Switch Characteristics” section on page 5-3 and “HSRP and Standby Command Switches” section on

page 5-10. To create a cluster standby group, select Cluster > Standby Command Switches

(Figure 5-10).

Instead of using CMS to add switches to a standby group and to bind the standby group to a cluster, you

can use the standby ip, standby name, standby priority interface configuration commands and the

cluster standby group global configuration command.

Note • When the command switch is a Catalyst 3550 switch, all standby command switches must be

Catalyst 3550 switches or Catalyst 2950 switches running Cisco IOS Release 12.1(6)EA2 or

later.

• When the command switch is a Catalyst 2950 switch running Cisco IOS Release 12.1(6)EA2 or

later, all standby command switches must be Catalyst 2950 switches running Cisco IOS

Release 12.1(6)EA2 or later.

• When the Catalyst 2950 command switch is running Cisco IOS Release 12.0(5)WC2 or earlier, the

standby command switches can be these switches also running Cisco IOS Release 12.0(5)WC2 or

earlier: Catalyst 2900 XL, Catalyst 2950, and Catalyst 3500 XL switches.

These abbreviations are appended to the switch host names in the Standby Command Group list to show

their eligibility or status in the cluster standby group:

• AC—Active command switch

• SC—Standby command switch

• PC—Member of the cluster standby group but not the standby command switch

• HC—Candidate switch that can be added to the cluster standby group

• CC—Command switch when HSRP is disabled

You must enter a virtual IP address for the cluster standby group. This address must be in the same subnet

as the IP addresses of the switch. The group number must be unique within the IP subnet. It can be from

0 to 255, and the default is 0. The group name can have up to 31 characters.

The Standby Command Configuration window uses the default values for the preempt and name

commands that you have set by using the CLI. If you use this window to create the HSRP group, all

switches in the group have the preempt command enabled. You must also provide a name for the group.

Note The HSRP standby hold time interval should be greater than or equal to 3 times the hello time

interval. The default HSRP standby hold time interval is 10 seconds. The default HSRP standby hello

time interval is 3 seconds. For more information about the standby hold time and hello time intervals,

refer to the Cisco IOS Release 12.0 documentation set on Cisco.com.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 321 322

Sin comentarios

Cisco Catalyst 2900 Series XL Especificaciones Pagina 115