Cisco Catalyst 2900 Series XL Especificaciones descargar pdf (Pagina 250)

9-16

Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide

78-6511-06

Chapter9 Troubleshooting

Recovery Procedures

Step 17 The initial configuration is displayed:

The following configuration command script was created:

ip subnet-zero

interface VLAN1

ip address 172.20.153.36 255.255.255.0

ip default-gateway 172.20.153.01

hostname host_name

enable secret 5 $1$M3pS$cXtAlkyR3/6Cn8/

line vty 0 15

password telnet_password

snmp community private rw

snmp community public ro

cluster enable cls_name

end

Step 18 Verify that the information is correct.

• If the information is correct, enter Y at the prompt, and press Return.

• If the information is not correct, enter N at the prompt, press Return, and begin again at Step 1.

Use this configuration? [yes/no]: y

Step 19 Start your browser, and enter the switch IP address that you entered in Step 7.

Step 20 Click Cluster Management Suite to display CMS.

It prompts you to add the candidate switches. The password of the failed command switch is still valid

for the cluster. Enter it when candidate switches are proposed for cluster membership, and click OK.

Recovering from a Failed Command Switch Without Replacing the Command Switch

If a command switch fails and there is no standby command switch configured, member switches

continue forwarding among themselves, and they can still be managed through normal standalone

means. You can configure member switches through the console-port CLI, and they can be managed

through SNMP, HTML, and Telnet after you assign an IP address to them.

The password you enter when you log in to the command switch gives you access to member switches.

If the command switch fails and there is no standby command switch, you can use the command-switch

password to recover. For more information, see the “Recovering from a Command Switch Failure”

section on page 9-11.

1 2 ... 245 246 247 248 249 250 251 252 253 254 255 ... 321 322

Sin comentarios

Cisco Catalyst 2900 Series XL Especificaciones Pagina 250