Cisco Catalyst 2900 Series XL Especificaciones descargar pdf (Pagina 81)

3-7

Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide

78-6511-06

Chapter 3 Getting Started with the CLI

Accessing the CLI

This procedure assumes you have already assigned IP information and password to the switch or

command switch. You can assign this information to the switch in these ways:

• Using the setup program, as described in the release notes

(http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/index.htm).

• Manually assigning an IP address and password, as described in the “Changing IP Information”

section on page 6-2 and “Assigning Passwords and Privilege Levels” section on page 6-11.

Considerations for assigning this information to a command switch and cluster members are

described in the “IP Addresses” section on page 5-13 and “Passwords” section on page 5-14.

To access the CLI from a terminal session, follow these steps:

Step 1 Start up the emulation software (such as ProComm, HyperTerminal, tip, or minicom) on the management

station.

Step 2 If necessary, reconfigure the terminal-emulation software to match the switch console port settings

(default settings are 9600 baud, no parity, 8 data bits, and 1 stop bit).

Step 3 Establish a connection with the switch by either

• Connecting the switch console port to a management station or dial-up modem. For information

about connecting to the console port, refer to the switch hardware installation guide.

• Using any Telnet TCP/IP package from a remote management station. The switch must have

network connectivity with the Telnet client, and the switch must have an enable secret password

configured. For information about configuring the switch for Telnet access, see the “SNMP Network

Management Platforms” section on page 4-5.

The switch supports up to seven simultaneous Telnet sessions. Changes made by one Telnet user are

reflected in all other Telnet sessions.

After you connect through the console port or through a Telnet session, the User EXEC prompt appears

on the management station.

Accessing the CLI from a Browser

This procedure assumes you have met the software requirements, (including browser and Java plug-in

configurations) and have assigned IP information and a Telnet password to the switch or command

switch, as described in the release notes

(http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/index.htm).

Caution Copies of the CMS pages you display are saved in your browser memory cache until you exit the

browser session. A password is not required to redisplay these pages, including the Cisco Systems

Access page. You can access the CLI by clicking Web Console - HTML access to the command

line interface from a cached copy of the Cisco Systems Access page. To prevent unauthorized access

to CMS and the CLI, exit your browser to end the browser session.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 321 322

Sin comentarios

Cisco Catalyst 2900 Series XL Especificaciones Pagina 81