Cisco SCE 1000 2xGBE Guía de usuario descargar pdf (Pagina 192)

100

101

Chapter 6 Control Configuration

Entering LineCard Interface Configuration Mode

SCE 1000 2xGBE Release 2.0.10 User Guide

6-46 OL-7117-02

To install an application:

Step 1 From the SCE 1000(config if)# prompt, type pqi install file filename

[options] and press Enter.

The specified pqi file is installed using the installation options specified (if any) and the

SCE 1000(config if)# prompt appears.

Note that this may take up to 5 minutes.

Note

Always run the pqi uninstall command before installing a new pqi file.

To uninstall an application:

Step 1 From the SCE 1000(config if)# prompt, type pqi uninstall file

filename and press Enter.

The specified pqi file is uninstalled and the SCE 1000(config if)# prompt appears.

You must specify the same pqi file that was installed.

Note that this may take up to 5 minutes.

To upgrade an application:

Step 1 From the SCE 1000(config if)# prompt, type pqi upgrade file filename

[options] and press Enter.

The specified pqi file is upgraded using the options specified (if any) and the SCE

1000(config if)# prompt appears.

You must specify the pqi file that was last used for upgrade.

Note that this may take up to 5 minutes.

1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 489 490

Comentarios a estos manuales

Sin comentarios

Cisco SCE 1000 2xGBE Guía de usuario Pagina 192

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cisco SCE 1000 2xGBE