Cisco SCE 1000 2xGBE Guía de usuario descargar pdf (Pagina 210)

100

101

Chapter 7 Line Configuration

Line Gigabit Ethernet Interfaces

SCE 1000 2xGBE Release 2.0.10 User Guide

7-16 OL-7117-02

Entering GigabitEthernet Line Interface Configuration Mode

To enter GigabitEthernet Interface Configuration Mode:

Step 1 To enter Global Configuration Mode, type configure and press Enter.

The SCE 1000(config)# prompt appears.

Step 2 Type interface GigaBitEthernet [0/1|0/2] and press Enter.

interface GigaBitEthernet 0/1 enables configuration of interface 1

interface GigaBitEthernet 0/2 enables configuration of interface 2

The SCE 1000(config if)# prompt appears.

EXAMPLE:

The following example shows how to enter Configuration Mode for the GigabitEthernet

Interface number 2.

SCE 1000(config)#interface GigabitEthernet 0/2

SCE 1000(config if)#

Configuring GigabitEthernet Auto-Negotiation

Auto-negotiation

By default, the SCE 1000 GigabitEthernet ports are configured with auto-negotiation disabled. In

bump-in-the-wire topologies, auto-negotiation may be enabled, as described below.

The following commands are relevant to auto negotiation:

• [no | default ] autonegotiate

Configuring the GigabitEthernet Auto-negotiation Mode

To configure GigabitEthernet auto-negotiation mode:

Step 1 From the SCE 1000(config if)# prompt, type auto-negotiate, and press Enter.

This configures the GigaBitEthernet to auto-negotiation mode.

Note

Auto-negotiation must be disabled when the SCE 1000is connected to traffic links via an external

optical splitter in external splitting topology.

1 2 ... 205 206 207 208 209 210 211 212 213 214 215 ... 489 490

Comentarios a estos manuales

Sin comentarios

Cisco SCE 1000 2xGBE Guía de usuario Pagina 210

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cisco SCE 1000 2xGBE