Cisco SCE 1000 2xGBE Guía de usuario descargar pdf (Pagina 326)

100

101

Appendix A

GigaBitEthernet Interface Configuration Mode Commands

SCE 1000 2xGBE Release 2.0.10 User Guide

A-56 OL-7117-02

queue queue-number bandwidth bandwidth burst-size burstsize

Sets the queue shaping.

Default Bandwidth=100000K (100 Mega bps), burst size=8000 (8 K bytes)

Authorization admin

Mode GigabitEthernet Interface Configuration

ARAMETERS

queue-number Queue-number from 1–4, where 4 is the highest priority (fastest).

1=BE, 2, 3=AF, and 4=EF. BE is the best effort queue, that is the

lowest priority. EF is the Expedited Forwarding queue, that is the

highest priority forwarding. The AF (Assured Forwarding) queues

are middle-priority, with 3 being a higher priority queue, that is,

packets from queue 3 are transferred faster than those in queue 2.

bandwidth Bandwidth measured in kbps. 0 disables packet transmission from

the queue. The maximum bandwidth is determined by the line rate.

Bandwidth is set in resolutions of ~140Kbps, that is rounded to the

nearest multiple of approximately 140 Kbps.

burstsize Burst size in bytes, from 0–16000000.

SAGE GUIDELINES

• This command is valid for the line interfaces only, Interface GigabitEthernet

0/#.

XAMPLES:

The following sets queue shaping for queue 1.

SCE 1000(config-if)#queue 2 bandwidth 20000 burstsize 1000

SCE 1000(config-if)#

1 2 ... 321 322 323 324 325 326 327 328 329 330 331 ... 489 490

Comentarios a estos manuales

Sin comentarios

Cisco SCE 1000 2xGBE Guía de usuario Pagina 326

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cisco SCE 1000 2xGBE