Cisco SCE 1000 2xGBE Guía de usuario descargar pdf (Pagina 87)

100

101

Chapter 4 Installation and Startup

Connecting the Local Console

SCE 1000 2xGBE Release 2.0.10 User Guide

OL-7117-02 4-25

The above SCE 1000 port parameters are fixed and are not configurable.

To set up the local console:

Step 1 Plug the enclosed RS-232 serial cable into the CON port on the front panel of the SCE

1000.

Make sure that you push on the RJ-45 connector (attached to the RS-232 serial cable)

until you hear a “click”, which indicates that the connector is fully inserted and secured

in the receptacle. Gently pull on the plug to confirm whether the plug is locked into the

socket.

Step 2 Connect the other end of the serial cable (with an attached DB-9 connector) to the

VT100 compatible local (serial) terminal.

Step 3 Make sure the local terminal is configured as a VT-100 terminal, according to the fixed

SCE 1000 CON port parameters.

Step 4 Press Enter several times until the setup configuration dialog is entered.

--- System Configuration Dialog ---

At any point you may enter a question mark ‘?’ followed by ‘Enter’ for help.

Use ctrl-C to abort configuration dialog at any prompt.

Use ctrl-Z to jump to the end of the configuration dialog at any prompt.

Default settings are in square brackets ‘[]’.

Would you like to continue with the System Configuration Dialog? [yes/no]: y

Step 5 Type y and press Enter.

The system configuration dialog begins.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 489 490

Comentarios a estos manuales

Sin comentarios

Cisco SCE 1000 2xGBE Guía de usuario Pagina 87

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cisco SCE 1000 2xGBE