Cisco Catalyst 7500 Series Especificaciones descargar pdf (Pagina 140)

REVIEW DRAFT—CISCO CONFIDENTIAL

3-26

Cisco 7500 Series Installation and Configuration Guide

OL-5008-03 B0

Chapter 3 Installing a Cisco 7500 Series Router

Installing the Cisco 7513, Cisco 7513-MX, and Cisco 7576

Step 4 Replace the card cage assembly. (See the procedure in the “Installing the Card Cage Assembly” section

on page 7-9.)

Step 5 Replace the power supplies. (See the “Installing Cisco 7513, Cisco 7513-MX, and Cisco 7576 Power

Supplies” section on page 3-27.)

Step 6 Replace the processor modules in the card cage. (See the procedure in Figure 3-14.) Check all ejector

levers and ensure the processor modules are securely installed; tighten any that are loose.

This completes the procedure for installing the Cisco 7513, Cisco 7513-MX, and Cisco 7576. Proceed

to the “Attaching the Cisco 7513, Cisco 7513-MX, and Cisco 7576 Cable-Management Bracket” section

on page 3-26.

Attaching the Cisco 7513, Cisco 7513-MX, and Cisco 7576 Cable-Management

Bracket

Use the following procedure to install the cable-management bracket. You will need a large flat-blade

screwdriver for this procedure.

Step 1 Locate the two slotted screws between the blower module and the card cage opening at the interface

processor end of the router. (See Figure 3-16.)

Figure 3-16 Installing the Cable-Management Bracket on a Cisco 7513, Cisco 7513-MX, and

Cisco 7576

Step 2 Loosen these two screws using the flat-blade screwdriver.

Step 3 Place the bracket over the screws, as shown in Figure 3-16.

Step 4 Tighten the screws.

122372

Loosen

screws (2)

Bracket

Blower

module

Card cage

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 302 303

Sin comentarios

Cisco Catalyst 7500 Series Especificaciones Pagina 140