Cisco Catalyst 7500 Series Especificaciones descargar pdf (Pagina 257)

REVIEW DRAFT—CISCO CONFIDENTIAL

8-19

Cisco 7500 Series Installation and Configuration Guide

OL-5008-03 B0

Chapter 8 Troubleshooting a Cisco 7500 Series Router

Using Cisco 7500 Series System LEDs

Troubleshooting the Interface Processors

This section provides information on troubleshooting the interface processors.

Check the following to help isolate the problem:

• Are all interface processor enabled LEDs on?

If yes, the system is operational. Proceed to the instructions for configuring the interfaces in the

appropriate software documentation.

• Are any interface processor enabled LEDs off?

–

If any of the enabled LEDs are off, first check each RSP normal LED, which will be on if the

system booted the RSP successfully.

–

If the enabled LED on an individual interface processor is off, suspect that the interface

processor has pulled away from the backplane. You do not have to turn off the system power to

remove and replace an interface processor. Use the ejector levers to eject and reseat the interface

processor, and then tighten both of the captive installation screws. After the system reinitializes

the interfaces, the enabled LED on the interface processor should go on.

Note More specific interface processor troubleshooting information is discussed in the companion publication

Interface Processor Installation and Configuration Guide, which shipped with your Cisco 7500 series

router, and in the individual configuration notes that shipped with your interface processors.

If you experience trouble with the startup that is not resolved with these procedures, contact a service

representative for assistance and further instructions.

Using Cisco 7500 Series System LEDs

The RSPs and power supplies in all of the Cisco 7500 series routers have LEDs that indicate specific

behavior. The Cisco 7507, Cisco 7507-MX, Cisco 7513, Cisco 7513-MX, and Cisco 7576 routers also

have front-panel LEDs. (The Cisco 7505 does not have front-panel LEDs.)

Use the information in the following sections to interpret the LED indications for your system:

• Using the Front-Panel System LEDs, page 8-19 (for Cisco 7507, Cisco 7507-MX, Cisco 7513, Cisco

7513-MX, and Cisco 7576 routers)

• Using the RSP LEDs, page 8-21 (for all Cisco 7500 series RSPs)

• Using the Power Supply LEDs, page 8-23 (for all Cisco 7500 series power supplies)

Note Specific interface processor LED information is discussed in the companion publication Interface

Processor Installation and Configuration Guide, which shipped with your Cisco 7500 series router, and

in the individual configuration notes that shipped with your interface processors.

Using the Front-Panel System LEDs

This section describes the indications for the front-panel LEDs on the Cisco 7507, Cisco 7507-MX,

Cisco 7513, Cisco 7513-MX, and Cisco 7576. (The Cisco 7505 has no front-panel system LEDs.)

1 2 ... 252 253 254 255 256 257 258 259 260 261 262 ... 302 303

Sin comentarios

Cisco Catalyst 7500 Series Especificaciones Pagina 257