Cisco Catalyst 7500 Series Especificaciones descargar pdf (Pagina 149)

CHAPTER

4-1

Cisco 7500 Series Installation and Configuration Guide

OL-5008-03 B0

Performing a Basic Configuration of the System

This chapter describes the procedures for performing a basic configuration of your Cisco 7500 series

router. It guides you through a basic router configuration, which is sufficient for you to access your

network. Complex configuration procedures are beyond the scope of this text, and can be found in the

configuration publications listed in the “If You Need More Configuration Information” section on

page 4-32.

Note The Cisco IOS command examples in this chapter are from Release 11.1(8)CA. The examples might

appear differently on your system depending on the Cisco IOS software release in use, and the router

model being configured. If you are using an RSP8, note that it is only compatible with specific Cisco

IOS 12.0 releases, examples of which are not included in this guide. Refer to the Route Switch Processor

(RSP8) Installation and Configuration Guide for specific information on configuring a router equipped

with an RSP8. When configuring a Cisco 7576, you will configure router A and then router B.

The following sections provide information for configuring your Cisco 7500 series router:

• Starting the System and Observing Initial Conditions, page 4-2

• Overview of Software Configuration Register Settings at Startup, page 4-3

• Configuring the Software Configuration Register, page 4-4

• Booting the Cisco 7500 Series Router for the First Time, page 4-8

• Using the Enable Secret and the Enable Password, page 4-8

• Recovering a Lost Password, page 4-9

• Configuring the Cisco 7500 Series System, page 4-11

• Implementing Other Configuration Tasks, page 4-19

• What Do I Do Now?, page 4-20

• Using the Flash Memory Cards in the RSPs, page 4-20

• If You Need More Configuration Information, page 4-32

To configure a Cisco 7500 series router from a console, you need to connect a terminal to the router’s

console port. Configuration requires access to the console port on each Route Switch Processor (RSP)

in your router.

Note You should also use the companion publication Interface Processor Installation and Configuration

Guide in conjunction with the basic configuration information in this chapter.

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 302 303

Sin comentarios

Cisco Catalyst 7500 Series Especificaciones Pagina 149