Cisco Catalyst 7500 Series Especificaciones descargar pdf (Pagina 168)

4-20

Cisco 7500 Series Installation and Configuration Guide

OL-5008-03 B0

Chapter 4 Performing a Basic Configuration of the System

What Do I Do Now?

After you have installed the Cisco 7500 series router hardware, checked all external connections, turned

on the system power, allowed the system to boot up, and minimally configured the system, you might

need to perform more complete and complex configurations, which are beyond the scope of this text.

For specific information on more complex system and interface configuration and, if necessary,

troubleshooting, refer to the publications listed in the “If You Need More Configuration Information”

section on page 4-32.

Note For basic configuration information on each of the interface processors available for the Cisco 7500

series routers, refer to the companion publication Interface Processor Installation and Configuration

Guide, or to the individual configuration notes that might have shipped with selected interface

processors.

Using the Flash Memory Cards in the RSPs

This section describes procedures for using the Flash memory cards in the RSPs in the Cisco 7500 series

routers.

Note The Flash memory card can be inserted and removed with the power on. In the following procedures, the

term RSP refers to the RSP2, RSP4, and RSP8. Specific differences are clearly noted.

This section includes the following Flash memory card information:

• Installing and Removing a Flash Memory Card in an RSP, page 4-20

• Formatting a Flash Memory Card, page 4-24

• Copying Files to Flash Memory, page 4-25

• Making a Flash Memory Card Image Bootable, page 4-25

• Enabling Booting from Flash Memory, page 4-26

• Additional Commands Associated with Flash Memory, page 4-26

• Additional Procedures Associated with Flash Memory Cards, page 4-27

For additional Flash memory-related command descriptions and configuration information, refer to the

Cisco IOS Configuration Fundamentals Command Reference and the Cisco IOS Configuration

Fundamentals Configuration Guide. See the “If You Need More Configuration Information” section on

page 4-32 for information on obtaining these publications.

You can also refer to the publication Flash Memory Card Installation Instructions (Document Number

78-2083-xx). This publication ships with Flash memory cards shipped as spare parts.

Installing and Removing a Flash Memory Card in an RSP

The RSP has two PC Card slots—slot 0 and slot 1—into which you can install a Flash memory card. In

the RSP2, RSP4, and RSP8, the orientation is vertical. PC Card slot 0 is on the left and slot 1 is on the

right. (See Figure 4-1 and Figure 4-2).

1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 302 303

Sin comentarios

Cisco Catalyst 7500 Series Especificaciones Pagina 168