Cisco Catalyst 7500 Series Especificaciones descargar pdf (Pagina 179)

4-31

Cisco 7500 Series Installation and Configuration Guide

OL-5008-03 B0

Chapter 4 Performing a Basic Configuration of the System

Using the Flash Memory Cards in the RSPs

4 6176844 Jul 11 1996 23:04:10 rsp-jv-mz.111-472

5 1186 Jul 12 1996 16:56:50 myfile2

9197156 bytes available (11381148 bytes used)

Router#

This completes the procedure for copying files between RSP NVRAM and a Flash memory card.

Copying a Configuration from RSP DRAM to a Flash Memory Card on the RSP

You can use the command copy running-config [slot0: | slot1:]:filename for the copy procedure where

running-config is the file’s source (the temporary configuration in DRAM) and [slot0: | slot1:]:filename

is the file’s destination in either of the Flashmemory cards.

An example of the copy startup-config slot0:filename command follows:

Router# copy running-config slot0:myfile2

20575008 bytes available on device slot0, proceed? [confirm]

Address or name of remote host [1.1.1.1]?

Loading new.image from 1.1.1.1 (via Ethernet1/0): !!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!![OK - 7799951/15599616 bytes] CCCCCCCCCCCCCCCCCCC

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

Router#

Note In the preceding example, the exclamation points (!!!) appear as the file is copied. The “C” characters

signify calculation of the checksum—a verification that the file has been correctly copied.

To verify the file was copied correctly, use the dir command as follows:

Router# dir slot0:

-#- -length- -----date/time------ name

1 5200084 Jul 11 1996 19:24:12 rsp-jv-mz.111-4

3 1215 Jul 11 1996 20:30:52 myfile1

4 6176844 Jul 11 1996 23:04:10 rsp-jv-mz.111-472

5 1186 Jul 12 1996 16:56:50 myfile2

9197156 bytes available (11381148 bytes used)

This completes the procedure for copying a configuration file from RSP DRAM to a Flash memory card.

Copying a Configuration File from a Flash Memory Card to RSP NVRAM

This section describes the procedure for copying your configuration file from the Flash memory card in

PC Card slot 0 or slot 1 back to NVRAM.

Use the copy [slot0: | slot1:]:filename startup-config command for this copy procedure, in which

[slot0: | slot1:]:filename is the source of the file (Flash memory card), and startup-config is the

destination (NVRAM).

An example of the copy slot0:filename startup-config command follows:

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 302 303

Sin comentarios

Cisco Catalyst 7500 Series Especificaciones Pagina 179