Cisco Catalyst 7500 Series Especificaciones descargar pdf (Pagina 189)

5-7

Cisco 7500 Series Installation and Configuration Guide

OL-5008-03 B0

Chapter 5 Maintaining Your Cisco 7505 Router

Maintenance Procedures for the Cisco 7505

Use the following procedure to replace the fan tray:

Step 1 Replace the fan tray. Hold the fan tray assembly in the position shown in Figure 5-2. Keep the tray as

straight as possible, or you might have trouble inserting it into the chassis.

Note Before inserting the fan tray, compare the hardware inside the chassis to Figure 5-3. The runner on the

bottom of the fan tray has to slide along in the track on the floor. At the same time, the runner on the top

of the tray has to slide through the notch at the top of the chassis opening, then over the top of the card

cage while staying to the left of the L-bracket on the chassis ceiling.

Step 2 Insert the top runner of the fan tray through the notch in the top of the chassis. Continue pushing the tray

into the chassis, ensuring that the bottom runner slides into the track on the floor of the chassis. If the

tray hangs up, pull it back out a few inches and try pushing it back in again. If the runners seem to be

catching on the brackets, push the tray slightly toward the left when inserting it again.

Step 3 Slide the tray back into the chassis, pushing it all the way in until the circuit board snaps into the

backplane socket.

Step 4 Replace the M4 screw in the tab and tighten it with a number 2 Phillips screwdriver. (See the cutaway

view of this screw in Figure 5-2.)

Step 5 Replace the cover panel. (Follow Step 1 through Step 4 in the procedure for replacing the cover panel in

the “Removing and Replacing the Cisco 7505 Cover Panel” section on page 5-3.)

This completes the fan tray replacement procedure.

Removing and Replacing the Cisco 7505 Power Harness Cover

You must remove the power harness cover to access the power supply. A single M3 Phillips screw

secures the power harness cover to the backplane cover.

Warning

Before working on the chassis or near power supplies, disconnect the power cable on AC units or

disconnect the power at the circuit breaker on DC units.

Use the following procedure to remove the power harness cover:

Step 1 Turn off the system power switch and disconnect the power cable from the power source.

Step 2 Remove the chassis cover panel. (Follow Step 1 and Step 2 in the procedure for removing the chassis

cover panel in the “Removing and Replacing the Cisco 7505 Cover Panel” section on page 5-3.)

1 2 ... 184 185 186 187 188 189 190 191 192 193 194 ... 302 303

Sin comentarios

Cisco Catalyst 7500 Series Especificaciones Pagina 189