Cisco 3002 - VPN Hardware Client Guía de usuario descargar pdf (Pagina 106)

Configuration | Policy Management | Traffic

Management | PAT

The Configuration | Policy Management | Traffic Management | PAT screen displays.

Figure 11-3: Configuration | Policy Management | Traffic Management | PAT screen

PAT mode provides many-to-one translation; that is, it translates many private network addresses to the

single address configured on the public network interface.

Enable

To enable PAT, click Enable.

Configuration | Policy Management | Traffic Management |

PAT | Enable

This screen lets you enable or disable PAT, which applies PAT to all configured traffic flowing from the

private interface to the public interface.

Figure 11-4: Configuration | Policy Management | Traffic Management | PAT | Enable screen

PAT Enabled

Check the box to enable Client Mode (PAT), or clear it to enable Network Extension Mode.

Note: Remember that to use Network Extension Mode, you must configure an IP address other than the default

for the Private interface. If you don’t change the IP address of the Private interface, you can’t disable

PAT.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 219 220

Sin comentarios

Cisco 3002 - VPN Hardware Client Guía de usuario Pagina 106