Cisco 3002 - VPN Hardware Client Guía de usuario Pagina 45

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 220
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 44
3-1
VPN 3002 Hardware Client User Guide
CHAPTER
3
Interfaces
This section of the VPN 3002 Hardware Client Manager applies functions that are interface-specific,
rather than system-wide.
You configure two network interfaces for the VPN 3002 to operate as a VPN device: the Private interface
and the Public interface. If you used Quick Configuration as described in the VPN 3002 Hardware Client
Getting Started manual, the system supplied many default parameters for the interfaces. Here you can
configure them explicitly.
The VPN 3002 includes some IP routing functions: static routes, and DHCP. You configure static routes,
the default gateway, and DHCP in the IP Routing section; see the
Configuration | System | IP Routing
screens.
Configuration | Interfaces
This section lets you configure the Private and Public interfaces.
Private is the interface to your private network (internal LAN).
Public is the interface to the public network.
Configuring an Ethernet interface includes supplying an IP address and subnet mask, and setting speed
and transmission mode.
Note: Interface settings take effect as soon as you apply them. If the system is in active use, changes may affect
tunnel traffic.
The table shows all installed interfaces and their status.
Vista de pagina 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 219 220

Comentarios a estos manuales

Sin comentarios