Cisco 3002 - VPN Hardware Client Guía de usuario Pagina 46

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 220
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 45
3 Interfaces
3-2
VPN 3002 Hardware Client User Guide
Figure 3-1: VPN 3002-8E Configuration | Interfaces screen
To configure a module, either click the appropriate link in the status table; or use the mouse pointer to
select the module on the back-panel image, and click anywhere in the highlighted area.
Interface
The VPN3002 interface installed in the system. To configure an interface, click the appropriate link.
Private, Public
To configure Ethernet interface parameters, click the appropriate highlighted link in the table or click in
a highlighted module on the back-panel image. See
Configuration | Interfaces | Private/Public.
Status
The operational status of this interface
PWR green = Configured, enabled, and operational; ready to pass data traffic.
SYS flashing amber = Configured but disabled or disconnected.
Testing = In test mode; no regular data traffic can pass.
Dormant = (Red) Configured and enabled but waiting for an external action, such as an incoming
connection.
Not Present = (Red) Missing hardware components.
Lower Layer Down = (Red) Not operational because a lower-layer interface is down.
Unknown = (Red) Not configured or not able to determine status.
Not Configured = Present but not configured.
Waiting for DHCP = Waiting for DHCP to assign an IP address.
Vista de pagina 45
1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 219 220

Comentarios a estos manuales

Sin comentarios