Cisco WS-X4604-GWY - VoIP Gateway Especificaciones Pagina 118

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 262
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 117
Chapter 5 Dial Plan Architecture and Configuration
Special Dial String Considerations
5-10
Cisco IP Telephony Network Design Guide
78-11103-03
Digit translation can also be performed within the route pattern structure using
called/calling party transformation, which performs the same digit translation
functions for both incoming and outgoing calls. This means that within a route
pattern, three types of digit manipulation can be performed on a called number:
Discard digits
Apply called-party transformation mask
Prefix digits
In the following example, a route pattern of 2.XXXX is defined. The calling
number is 1000, but the call needs to go to a PBX with a called party number of
444XXXX and a calling party number of 919392XXXX. The Cisco CallManager
route pattern would be treated as follows:
Step 1 Apply the calling party transformation mask of 919392XXXX. This prefixes
91939 to the calling number.
Step 2 Discard the access code (2), leaving just XXXX.
Step 3 Prefix the digits 444.
An alternative way to accomplish steps 2 and 3 would be to use a called-party
transformation mask of 444XXXX.
It is important to keep in mind that the calling party transformation mask applies
only to the calling numbers, while the other masks apply to the called numbers.
Cisco CallManager first discards digits, then applies the transformation mask,
and finally prefixes digits.
Special Dial String Considerations
You should try to make your dial plan as simple as possible and to minimize the
number of entries. The most efficient way to achieve this is to configure specific
dial plans only for locations on the network (IP WAN) and to use the local PSTN
gateway access code, such as 9 or 0 (zero), for locations that must be reached over
the PSTN, as well as for IP WAN calls if the IP WAN is down or has insufficient
resources. These are called on-net and off-net route patterns, respectively.
Vista de pagina 117
1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 261 262

Comentarios a estos manuales

Sin comentarios