Cisco WS-X4604-GWY - VoIP Gateway Especificaciones Pagina 139
- Pagina / 166
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
8-11
Cisco Catalyst 4000 Access Gateway Module Installation and Configuration Note
OL-3008-01
Chapter 8 Configuring the DSP Farm
Troubleshooting the AGM
phy register #18: C000
phy register #19: 1
phy register #20: 79
fcc_gfmr: 7C
PQII SCC specific errors:
0 buffer errors, 0 overflow errors
0 input aborts on late collisions
0 heartbeat failures, 0 cumulative deferred
Interface GigabitEthernet0/0(idb 0x812E0614)
Hardware is WISEMAN 2.1, network connection mode is force
network link is up
loopback type is none
GBIC is missing
idb->lc_ip_turbo_fs=0x0, ip_routecache=0x1(dfs=0/mdfs=0), max_mtu=1532
fx1000_ds=0x812E2258, registers=0x1A000000, curr_intr=0
rx cache size=800, rx cache end=672, rx_nobuffer=0
FX1000 registers:
CTRL =0x00B40045, STATUS=0x0000000F
FCAL =0x00000000, FCAH =0x00000000, FCT =0x00000000, FCTTV =0x00000000
RCTL =0x00428032, RDBAL0=0x13205000, RDBAH0=0x00000000, RDLEN0=0x00000800
RDH0 =0x00000037, RDT0 =0x00000036, RDTR0 =0x00000000, IMS =0x000002D6
TCTL =0x000400FA, TIPG =0x00A0080A, TQC =0x00000000, TDBAL =0x1312A000
TDBAH =0x00000000, TDLEN =0x00001000, TDH =0x00000052, TDT =0x00000052
TXCW =0x00000000, RXCW =0x5C000000, FCRTL =0x00000000, FCRTH =0x00000000
RDFH =0x8F0B0000, RDFT =0x8F0B0000, TDFH =0x28010000, TDFT =0x28010000
RX=normal, enabled TX=normal, enabled
Device status=full-duplex, link up, tx clock, rx clock
AN status=pending, SYNC'ed, rx idle stream, rx invalid symbols, rx idle char
PCI configuration registers:
bus_no=0, device_no=0
DeviceID=0x1000, VendorID=0x8086, Command=0x0116, Status=0x0200
Class=0x02/0x00/0x00, Revision=0x03, LatencyTimer=0xFC, CacheLineSize=0x08
BaseAddr0=0x20000004, BaseAddr1=0x00000000, MaxLat=0x00, MinGnt=0xFF
SubsysDeviceID=0x1000, SubsysVendorID=0x8086
Cap_Ptr=0x00000000 Retry/TRDY Timeout=0x0000FF00
PMC=0x00210001 PMCSR=0x00000000
FX1000 Internal Statistics:
rxring(128)=0x3205000, shadow=0x812E2554, head=55, rx_buf_size=512
txring(256)=0x312A000, shadow=0x812E2780, head=81, tail=81
tx_int_txdw=0, tx_int_txqe=0, rx_int_rxdmt0=0, rx_int_rxt0=0
tx_count=0, txring_full=0, rx_max=0, filtered_pak=0
rx_overrun=0, rx_seq=0, reg_read=0, reg_write=0
rx_count=128, throttled=0, enabled=0, disabled=0
rx_no_enp=0, rx_discard=0, link_reset=0, pci_rev=3
tbl_overflow=0, chip_state=2, tx_nonint_done=0, tx_limited=0
reset=11(init=1, check=0, restart=3, pci=0), auto_restart=0
tx_carrier_loss=0, fatal_tx_err=0
isl_err=0, wait_for_last_tdt=0, ctrl=800045, ctrl0=B40045
HW addr filter: 0x812E2FAC, ISL disabled, Promiscuous mode multicast
Entry= 0: Addr=0001.96C6.17FB
Entry= 1: Addr=0000.0000.0000
Entry= 2: Addr=0000.0000.0000
Entry= 3: Addr=0000.0000.0000
Entry= 4: Addr=0000.0000.0000
Entry= 5: Addr=0000.0000.0000
Entry= 6: Addr=0000.0000.0000
Entry= 7: Addr=0000.0000.0000
Entry= 8: Addr=0000.0000.0000
Entry= 9: Addr=0000.0000.0000
Entry=10: Addr=0000.0000.0000
Entry=11: Addr=0000.0000.0000
- Cisco Catalyst 4000 1
- Access Gateway Module 1
- CONTENTS 3
- Contents 4
- Audience 9
- Organization 9
- Conventions 10
- Safety Overview 11
- Related Documentation 12
- Obtaining Documentation 13
- Documentation Feedback 14
- Cisco.com 14
- Technical Assistance Center 15
- Overview 17
- IP Telephony Campus 18
- Large Branch Office 18
- • the console port on the AGM 19
- Hardware Features 20
- Cisco Catalyst 4000 DSP Set 21
- Data Interface Modules 21
- Voice Interface Modules 22
- Signaling Support on AGM 23
- Switch-Type Support on AGM 23
- Software Features 24
- Security 25
- Resiliency 25
- Network Management Support 26
- Preparing to Install the AGM 27
- Installing the AGM 29
- Hot-Swapping Features 31
- Checking the AGM Operation 32
- Power Supply 1 34
- Power Supply 2 34
- WAN Interface Modules 35
- SEE MANUAL 36
- INSTALLATION 36
- Straight-through 41
- RJ-11-to-RJ-11 cable 41
- RJ-11 ports 41
- RJ-11 wall jack 41
- RJ-21 Connectors 42
- Velcro strap 43
- ConfigurableNot used 45
- RJ-48S ports 47
- RJ-48S wall jack 47
- RJ-48C ports 48
- NT1 device 48
- RJ-45-to-RJ-45 cable 48
- S/T port 48
- RJ-48C-to-RJ-48C cable 50
- RJ-48C wall jack 50
- Booting the AGM 53
- Accessing the AGM 54
- Configuring the Console Port 55
- Connecting a Terminal 56
- Connecting a Modem 56
- Using the Cisco IOS CLI 57
- Getting Help 58
- Command Modes 58
- Gateway(config-if)# 59
- (config 59
- Gateway(config-dial-peer)# 59
- Saving Configuration Changes 60
- Table 4-2 ISDN Switch Types 68
- Configuring T1 Interfaces 69
- Configuring E1 Interfaces 71
- Preparing to Configure VoIP 75
- Configuring Voice Interfaces 76
- MGCP Configuration 77
- Enabling MGCP 78
- • E&M Wink Start 81
- • E&M Delay Start 81
- H.323 Gateway Configuration 86
- FXS Emulation Example 90
- FXO Emulation Example 90
- E&M Emulation Example 91
- Configuring ISDN BRI Lines 92
- Gateway 1 Configuration 95
- T1/E1 Configuration (H.323) 96
- T1/PRI Configuration Example 97
- E1/PRI Configuration Example 98
- Configuration for AGM AGLB-1 99
- Configuration for AGM AGLB-2 100
- FXO Connection to PSTN 101
- San Jose Salt Lake City 102
- AGM SLC Configuration 103
- OL-3008-01 104
- Configuring FXS Voice Ports 106
- Validating the Configuration 107
- Fine-Tuning FXS Voice Ports 108
- Activating the Voice Port 110
- Sample Configuration 110
- Verifying the Configuration 120
- Sample Configurations 121
- Configuration File for Peer 1 124
- Configuration File for Peer 2 126
- Configuring the DSP Farm 129
- IP Telephony Gateway Mode 130
- Conferencing Service 131
- Transcoding Service 132
- Troubleshooting the AGM 137
- Troubleshooting Controller 138
- Troubleshooting Hardware 141
- Troubleshooting TDM 141
- Troubleshooting DSP 142
- SIMM 3 DSP 12–17 143
- SIMM 4 DSP 18–23 143
- Entering ROM Monitor Mode 145
- Configuring for Autoboot 146
- ROM Monitor Commands 147
- Debugging Commands 150
- Cookie Commands 151
- Upgrading the ROM Monitor 157
- Using Loss Plan Defaults 159
- Transmission Loss Plan 160
- Console Connector Pinouts 161
- Management Port Pinouts 161
- Identifying a Rollover Cable 163
- Connecting to a PC 164
- Connecting to a Terminal 164
Relacionado con productos y manuales para Gateways / Controladores Cisco WS-X4604-GWY - VoIP Gateway
(14 paginas)
(90 paginas)
(25 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.046 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales