Cisco WS-X4604-GWY - VoIP Gateway Especificaciones descargar pdf (Pagina 56)

3-4

Cisco Catalyst 4000 Access Gateway Module Installation and Configuration Note

OL-3008-01

Chapter 3 Configuring the AGM for the First Time

Preparing to Configure the AGM

Connecting a Terminal

To connect a terminal to the console port using the cable and adapters provided with the Catalyst 4000

family switch, ensure that the console port mode switch is in the in position (factory default). Connect

to the port using the RJ-45-to-RJ-45 cable and RJ-45-to-DB-25 DTE adapter or RJ-45-to-DB-9 DTE

adapter (labeled “Terminal”).

To connect a terminal using a Catalyst 5000 Family supervisor engine III console cable, place the

console port mode switch in the out position. Connect to the port using the Catalyst 4000 family

supervisor engine III cable and the appropriate adapter for the terminal connection.

Check the documentation that came with your terminal to determine the baud rate. The baud rate of the

terminal must match the default baud rate (9600 baud) of the console port.

Set up the terminal as follows:

• 9600 baud

• 8 data bits

• No parity

• 1 stop bit

• No flow control

Connecting a Modem

To connect a modem to the console port, ensure that the console port mode switch is in the in position

(factory default position). Connect the modem to the port using the RJ-45-to-RJ-45 cable and the

RJ-45-to-DB-25 DCE adapter (labeled “Modem”).

Configuring the Management Port

You can manage the AGM through the 10/100 management port by assigning it an IP address.

Caution By default, the Fast Ethernet interface does not route data traffic. We do not recommend that you

override this default configuration.

The supervisor engine reports one IP address assigned to the AGM that can be used for network

management through the Cisco Stack MIB.

If the Ethernet 10/100 management port is up and an IP address has been configured, the AGM selects

the IP address assigned to the 10/100 Ethernet management port. If the management port is down or an

IP address has not been configured, the AGM randomly selects an IP address that has been assigned to

one of the Gigabit Ethernet ports or port channels as the network management IP address, provided the

interface or subinterface associated with this IP address is up at the time of selection.

If the selected network management IP address is removed or the interface or subinterface associated

with this IP address is shut down, the AGM selects another IP address as a replacement.

If all the interfaces are down or no IP address has been assigned to any interface or subinterface that is

up, the IP address for network management is 0.0.0.0.

After each IP address selection or change of the IP address, the AGM sends an unsolicited message to

the supervisor engine, which then populates the IP address attribute of the Cisco Stack MIB entry of the

AGM.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 165 166

Comentarios a estos manuales

Sin comentarios

Cisco WS-X4604-GWY - VoIP Gateway Especificaciones Pagina 56

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores Cisco WS-X4604-GWY - VoIP Gateway