Cisco WS-X4604-GWY - VoIP Gateway Especificaciones descargar pdf (Pagina 55)

3-3

Cisco Catalyst 4000 Access Gateway Module Installation and Configuration Note

OL-3008-01

Chapter 3 Configuring the AGM for the First Time

Preparing to Configure the AGM

To download an image to bootflash from Catalyst Operating System on Supervisor Engine I and II,

access the AGM using the session command:

Console> (enable) session

To download an image to bootflash from Cisco IOS on supervisor engine III and IV, access the AGM

using the attach command:

Switch# attach module module_number

Enter the following command in privileged mode:

copy tftp: [/directory] /filename [/directory] /filename

Configuring the Console Port

The console port mode switch allows you to connect a terminal to the AGM using either a Catalyst 5000

family supervisor engine III console cable or the console cable and adapters provided with a

Catalyst 4000 family switch.

Note Use a paper clip or a small, pointed object to access the console port mode switch.

Use the console port mode switch as follows:

• Mode 1—Switch is in the (factory default) in position to connect a terminal to the console port using

the console cable and data terminal equipment (DTE) adapter labeled Terminal that shipped with

the switch.

You can also use this mode to connect a modem to the console port using the console cable and data

communications equipment (DCE) adapter (labeled “Modem”) that shipped with the switch.

• Mode 2—Switch is in the out position to connect a terminal to the console port using the Catalyst

5000 Family supervisor engine III console cable (not provided).

Note You should not have to connect a terminal to the AGM console port.

When your terminal is connected to the supervisor engine I or II console port, use the session command

to access the Layer 3 services module for Gateway configuration.

When your terminal is connected to the supervisor engineIII or IV console port, use the attach module

command to access the Layer 3 services module for Gateway configuration.

The console port allows you to access the AGM either locally (with a console terminal) or remotely (with

a modem). The console port is an EIA/TIA-232 asynchronous, serial connection with an RJ-45

connector.

For complete console port cabling specifications and pinouts, refer to the Catalyst 4000 Family

Installation Guide.

Note The accessory kit that shipped with your Catalyst 4000 family switch contains the cable and adapters

to connect a terminal or modem to the console port. These cables and adapters are the same as those

shipped with the Cisco 2500 series routers and other Cisco products.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 165 166

Sin comentarios

Cisco WS-X4604-GWY - VoIP Gateway Especificaciones Pagina 55