Cisco WS-X4604-GWY - VoIP Gateway Especificaciones descargar pdf (Pagina 30)

2-4

Cisco Catalyst 4000 Access Gateway Module Installation and Configuration Note

OL-3008-01

Chapter 2 Installing the Access Gateway Module

Installing the AGM

Caution To prevent ESD damage, handle the AGM by the carrier edges only. Moreover, you should use a

wrist strap or other grounding device to prevent ESD damage.

To install the AGM, perform these steps:

Step 1 Choose a slot for the new AGM.

Note The AGM can be inserted into slots 2 or 3 in the Catalyst 4003 switch and slots 2 through 6 in the

Catalyst 4006 switch. In the Catalyst 4003 and Catalyst 4006 switches, slot 1 is reserved for the

supervisor engine.

Ensure that you have enough clearance to accommodate any interface equipment that you will connect

directly to the AGM ports. If possible, place AGMs between empty slots that contain only switching

module filler plates.

Step 2 Loosen the captive installation screws securing the switching module filler plate (or the existing

switching module) to the desired slot.

Step 3 Remove the switching module filler plate (or the existing switching module). Save the switching

module filler plate for future use.

Note If you are removing an existing switching module, refer to the “Removing Catalyst 4000

Switching Modules (optional)” section on page 2-2.

Step 4 To install the new AGM, hold the switching module front panel with one hand, and place your other

hand under the carrier to support the module, as shown in Figure 2-2. Do not touch the printed circuit

boards or connector pins.

Step 5 Align the edges of the AGM carrier with the slot guides on the sides of the switch chassis, as shown in

Figure 2-2.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 165 166

Sin comentarios

Cisco WS-X4604-GWY - VoIP Gateway Especificaciones Pagina 30