Cisco WS-X4604-GWY - VoIP Gateway Especificaciones descargar pdf (Pagina 47)

2-21

Cisco Catalyst 4000 Access Gateway Module Installation and Configuration Note

OL-3008-01

Chapter 2 Installing the Access Gateway Module

Connecting the Voice and WAN Interface Modules

Step 1 Power off the AGM.

Step 2 Connect one end of the RJ-11 cable to one of the RJ48S ports of the module, as shown in Figure 2-14.

Step 3 Connect the other end of the cable to the RJ48S wall jack, as shown in Figure 2-14.

Figure 2-14 Connecting a 2-Port E/M Module (VIC-2E/M)

Step 4 Power on the AGM.

Step 5 verify the IN USE LED is green, indicating that line is in use.

Table 2-8 describes the E/M voice interface module LED.

Connecting the 2-Port ISDN BRI Modules

This section describes how to connect and verify the status of the 2-port ISDN BRI modules

(VIC-2BRI-S/T-TE).

Use the straight through RJ-48C-to-RJ-48C cable that shipped with your AGM.

To connect the 2-port ISDN BRI module, perform these steps:

Step 1 Power off the AGM.

Step 2 Connect one end of the cable to one of the RJ-48C ports of the module, as shown in Figure 2-15.

Step 3 Connect the other end of the cable to one of the RJ-48C S/T ports on an NT1 device, as shown in

Figure 2-15.

Straight-through

RJ-11-to-RJ-11 cable

RJ-48S ports

RJ-48S wall jack

58546

SEE MANUAL BEFORE INSTALLATION

VIC

E&M

IN USE

Table 2-8 E/M Voice Interface Module LED

LED Description

IN USE Green indicates that the line is active.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 165 166

Sin comentarios

Cisco WS-X4604-GWY - VoIP Gateway Especificaciones Pagina 47