Cisco WS-X4604-GWY - VoIP Gateway Especificaciones descargar pdf (Pagina 51)

2-25

Cisco Catalyst 4000 Access Gateway Module Installation and Configuration Note

OL-3008-01

Chapter 2 Installing the Access Gateway Module

Connecting a Terminal to the Console and Ethernet Management Ports

Step 5 Verify that the CD LED is green, indicating that the module’s internal DSU/CSU is communicating with

the DSU/CSU at the T1 or E1 service provider CO.

Table 2-11 describes the 2-port multiflex interface module LEDs.

If you have additional modules to install, proceed to the appropriate section in this document.

Connecting a Terminal to the Console and Ethernet Management

Ports

The console and 10/100 Mbps Ethernet management ports are located on the front panel of the AGM.

(See Figure 2-1) The console and Ethernet management ports use an RJ-45 media-dependent interface

crossed-over (MDIX) connector (see Figure 2-18). Table 2-12 lists the console port pinouts and

Table 2-13 lists the 10/100 Mbps Ethernet management port pinouts.

Note The MDIX ports are crossed over internally. For an MDI-to-MDI or MDIX-to-MDIX connection,

use a crossover cable. For an MDI-to-MDIX connection, use a straight-through cable, which allows

the Tx pins to connect with the Rx pins.

Figure 2-18 10/100Base-TX RJ-45 Connector Type

Table 2-11 2-Port Multiflex Trunk Interface Module LEDs

LED Description

AL Yellow indicates that there is a local or remote alarm state.

This LED is off during normal operation.

LP Yellow indicates that a loopback or line state has been

detected or has been manually set by the user. This LED is

off during normal operation.

CD Green indicates that a carrier has been detected and that the

internal DSU/CSU in the module is communicating with

another DSU/CSU. This LED is on during normal

operation.

H9463

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 165 166

Sin comentarios

Cisco WS-X4604-GWY - VoIP Gateway Especificaciones Pagina 51