Cisco WS-X4604-GWY - VoIP Gateway Especificaciones descargar pdf (Pagina 53)

CHAPTER

3-1

Cisco Catalyst 4000 Access Gateway Module Installation and Configuration Note

OL-3008-01

Configuring the AGM for the First Time

This chapter describes how to use the setup command facility to configure your Cisco Catalyst 4000

Access Gateway Module (AGM).

Note The setup command facility prompts you to enter information needed to quickly start the AGM

functioning. The facility steps you through a basic configuration, including configuring LAN and

WAN interfaces.

This chapter contains these major sections:

• Preparing to Configure the AGM, page 3-1

• Using the Cisco IOS CLI, page 3-5

• Interface Configuration Examples, page 3-8

Preparing to Configure the AGM

This section contains information you need to be familiar with before you begin to configure your AGM

for the first time, including interface numbering and steps to take before bringing your AGM online.

This section contains these subsections:

• Booting the AGM, page 3-1

• Downloading an Image to Bootflash, page 3-2

• Configuring the Console Port, page 3-3

• Configuring the Management Port, page 3-4

• Understanding the Interface Numbering, page 3-5

Booting the AGM

The factory configures the AGM to automatically load a Cisco IOS image the first time you insert the

module into a Catalyst 4000 family switch. The software configuration register in the AGM determines

where to find the image. The factory sets this register to load the IOS image into bootflash from

configuration register 0x0101. This register enables autoboot at register 0x0103.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 165 166

Sin comentarios

Cisco WS-X4604-GWY - VoIP Gateway Especificaciones Pagina 53