Cisco WS-X4604-GWY - VoIP Gateway Especificaciones Pagina 20
- Pagina / 166
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
1-4
Cisco Catalyst 4000 Access Gateway Module Installation and Configuration Note
OL-3008-01
Chapter 1 Overview
Hardware Features
Figure 1-3 shows the front-panel of the AGM. You can see the console port on the lower left and the Fast
Ethernet port immediately to the right of the console port.
Figure 1-3 Access Gateway Module Fast Ethernet and Console Ports
The AGM ports are named according to their positions in their respective slots. From the left, the slots
are numbered 1, 2, 3, and 4. Slots 1 and 2 are for VWICs, slot 3 is for VICs, and slot 4 is for multiflex
modules.
A VWIC, VIC, or WIC can have one or more ports, so ports on the interface modules are sequentially
numbered starting with 0 for the right-most port and increasing by one in the right to left direction.
Note The inverse port-numbering order is inherited from existing VWIC, VIC, and WIC port-numbering
conventions.
Hardware Features
The AGM supports the following hardware features:
• A DSP bank with 24 DSPs (4 SIMMs with 6 DSPs each) supporting a maximum of 96 voice
channels.
• Two voice or WAN interface module (VWIC) slots—Support VWICs, voice interface modules
(VICs), and WAN interface modules (WICs).
• One VIC slot—Supports the same VWICs and VICs as slots 1 and 2, but does not support WICs.
• One multiflex slot—Reserved for the 8-Port and 16-Port RJ21 FXS modules.
• One Fast Ethernet port—Reserved for management purposes only. It does not support data
switching or routing.
• One console port—For configuration purposes, you can connect via terminal or modem.
• One Gigabit Ethernet backbone interface—Standard IOS Gigabit Ethernet interface with the
following exceptions:
–
Supports 802.1q instead of ISL
–
Cannot be shut down without losing communication with the Supervisor Engine
• Encryption Service Adapter (ESA)—High-performance data encryption module to offload some of
the encryption processing from the AGM main processor and to improve performance.
0
1
2
3
D
SP BANK
R
EAD
Y
AC
TIV
E
STATUS
WAN GATEWAY
CONN
WS-X4604-GWY
CONN
CONSOLE
10/100MGT
VWIC 1
WIC
2A/S
1
SEE MANUAL BEFORE INSTALLATION
SEE
MANUAL
BEFORE
INSTALLATION
CTRLR T1 1 CTRLR T1 0
0
VIC
2FXS
VWIC
2MFT-T1-D1
VWIC 2 VIC 3
FLEXSLOT 4
FLEXSLOT 4 STATUS
73355
Two VIC/WIC slots
One VIC slot
One system and eight DSP
status LEDs
Console port
10/100 BaseT Ethernet
management port
04
15
26
37
WS-U4604-8FXS
FlexSlot
high density analog
- Cisco Catalyst 4000 1
- Access Gateway Module 1
- CONTENTS 3
- Contents 4
- Audience 9
- Organization 9
- Conventions 10
- Safety Overview 11
- Related Documentation 12
- Obtaining Documentation 13
- Documentation Feedback 14
- Cisco.com 14
- Technical Assistance Center 15
- Overview 17
- IP Telephony Campus 18
- Large Branch Office 18
- • the console port on the AGM 19
- Hardware Features 20
- Cisco Catalyst 4000 DSP Set 21
- Data Interface Modules 21
- Voice Interface Modules 22
- Signaling Support on AGM 23
- Switch-Type Support on AGM 23
- Software Features 24
- Security 25
- Resiliency 25
- Network Management Support 26
- Preparing to Install the AGM 27
- Installing the AGM 29
- Hot-Swapping Features 31
- Checking the AGM Operation 32
- Power Supply 1 34
- Power Supply 2 34
- WAN Interface Modules 35
- SEE MANUAL 36
- INSTALLATION 36
- Straight-through 41
- RJ-11-to-RJ-11 cable 41
- RJ-11 ports 41
- RJ-11 wall jack 41
- RJ-21 Connectors 42
- Velcro strap 43
- ConfigurableNot used 45
- RJ-48S ports 47
- RJ-48S wall jack 47
- RJ-48C ports 48
- NT1 device 48
- RJ-45-to-RJ-45 cable 48
- S/T port 48
- RJ-48C-to-RJ-48C cable 50
- RJ-48C wall jack 50
- Booting the AGM 53
- Accessing the AGM 54
- Configuring the Console Port 55
- Connecting a Terminal 56
- Connecting a Modem 56
- Using the Cisco IOS CLI 57
- Getting Help 58
- Command Modes 58
- Gateway(config-if)# 59
- (config 59
- Gateway(config-dial-peer)# 59
- Saving Configuration Changes 60
- Table 4-2 ISDN Switch Types 68
- Configuring T1 Interfaces 69
- Configuring E1 Interfaces 71
- Preparing to Configure VoIP 75
- Configuring Voice Interfaces 76
- MGCP Configuration 77
- Enabling MGCP 78
- • E&M Wink Start 81
- • E&M Delay Start 81
- H.323 Gateway Configuration 86
- FXS Emulation Example 90
- FXO Emulation Example 90
- E&M Emulation Example 91
- Configuring ISDN BRI Lines 92
- Gateway 1 Configuration 95
- T1/E1 Configuration (H.323) 96
- T1/PRI Configuration Example 97
- E1/PRI Configuration Example 98
- Configuration for AGM AGLB-1 99
- Configuration for AGM AGLB-2 100
- FXO Connection to PSTN 101
- San Jose Salt Lake City 102
- AGM SLC Configuration 103
- OL-3008-01 104
- Configuring FXS Voice Ports 106
- Validating the Configuration 107
- Fine-Tuning FXS Voice Ports 108
- Activating the Voice Port 110
- Sample Configuration 110
- Verifying the Configuration 120
- Sample Configurations 121
- Configuration File for Peer 1 124
- Configuration File for Peer 2 126
- Configuring the DSP Farm 129
- IP Telephony Gateway Mode 130
- Conferencing Service 131
- Transcoding Service 132
- Troubleshooting the AGM 137
- Troubleshooting Controller 138
- Troubleshooting Hardware 141
- Troubleshooting TDM 141
- Troubleshooting DSP 142
- SIMM 3 DSP 12–17 143
- SIMM 4 DSP 18–23 143
- Entering ROM Monitor Mode 145
- Configuring for Autoboot 146
- ROM Monitor Commands 147
- Debugging Commands 150
- Cookie Commands 151
- Upgrading the ROM Monitor 157
- Using Loss Plan Defaults 159
- Transmission Loss Plan 160
- Console Connector Pinouts 161
- Management Port Pinouts 161
- Identifying a Rollover Cable 163
- Connecting to a PC 164
- Connecting to a Terminal 164
Relacionado con productos y manuales para Gateways / Controladores Cisco WS-X4604-GWY - VoIP Gateway
(14 paginas)
(90 paginas)
(25 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.044 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales