Cisco WS-X4604-GWY - VoIP Gateway Especificaciones descargar pdf (Pagina 46)

2-20

Cisco Catalyst 4000 Access Gateway Module Installation and Configuration Note

OL-3008-01

Chapter 2 Installing the Access Gateway Module

Connecting the Voice and WAN Interface Modules

Figure 2-13 Connecting a 2-Port FXO Module (VIC-2FXO)

Step 4 Power on the AGM.

Step 5 verify the IN USE LED is green, indicating that the line is in use.

Table 2-7 describes the E/M voice interface module LED.

The VIC-2FXO-EU voice interface module is intended for use in Europe. In countries where PSTNs do

not use RJ-11 wall jacks, use a suitable adapter to convert the plug on an RJ-11 modular cable to the type

of wall outlet connector that is used in your country. These adapters are not sold by Cisco Systems but

are available from other vendors.

Caution Connect only an FXO interface that is approved for use in your country to the PSTN. Otherwise,

connect the FXO interface only to a PBX. Connections from the PBX to the PSTN are permitted.

Connecting the 2-Port E/M Voice Interface Modules

This section describes how to connect and verify the status of the 2-port E/M voice interface module

(VIC-2E/M).

Connecting the 2-Port E/M Module

Use a standard RJ-11 modular telephone cable to connect this interface to the PBX. Unlike the FXS and

FXO modules, the E/M module requires an RJ48S connector. The pinout depends on the PBX type and

connection.

To connect the 2-port E/M module, perform these steps:

Straight-through

RJ-11-to-RJ-11 cable

RJ-11 ports

RJ-11 wall jack

17370

SEE MANUAL BEFORE INSTALLATION

VIC

FXS

IN USE

Table 2-7 FXO Voice Interface Module LED

LED Description

IN USE Green indicates that the line is in use.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 165 166

Sin comentarios

Cisco WS-X4604-GWY - VoIP Gateway Especificaciones Pagina 46