Cisco WS-X4604-GWY - VoIP Gateway Especificaciones descargar pdf (Pagina 42)

2-16

Cisco Catalyst 4000 Access Gateway Module Installation and Configuration Note

OL-3008-01

Chapter 2 Installing the Access Gateway Module

Connecting the Voice and WAN Interface Modules

Table 2-5 describes the FXS voice interface module LED.

The VIC-2FXS-EU voice interface module is intended for use in Europe. In countries where PSTNs do

not use RJ-11 wall jacks, use a suitable adapter to convert the plug on an RJ-11 modular cable to the type

of wall jack connector that is used in your country. These adapters are not sold by Cisco Systems but are

available from other vendors.

Caution Connect only an FXS interface that is approved for use in your country to the PSTN. Otherwise,

connect the FXS interface only to a PBX.

Connecting the 8-Port RJ21 FXS Voice Interface Modules

This section describes how to connect and verify the status of an 8-port RJ21 FXS module

(WS-U4604-8FXS).

This section describes the following topics:

• RJ-21 Connectors, page 2-16

• Connecting the 8-Port RJ21 FXS Module, page 2-17

RJ-21 Connectors

Figure 2-9 shows examples of the RJ-21 telco connector for the RJ-21 port on the 8-port FXS module.

The connectors are available in three cable-to-connector orientations: 90 degrees, 110 degrees, and 180

degrees.

Figure 2-9 RJ-21 Category 5 Telco Interface Cable Connectors

Table 2-5 FXS Voice Interface Module LED

LED Description

IN USE Green indicates that an off-hook has been detected. Off indicates

that an on-hook has been detected.

180

RJ-21 port

110

48136

RJ-21

connector

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 165 166

Sin comentarios

Cisco WS-X4604-GWY - VoIP Gateway Especificaciones Pagina 42